SAFETECH ST80
SAFETECH ST80
Opale-Parachutes.com
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
© Copyright 2016 - Opale Aerosystem SARL - Tous droits réservés
Opale-Parachutes.com
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
© Copyright 2016 - Opale Aerosystem SARL - Tous droits réservés
Initiating and standby procedures
Initiating procedure Standby procedure
Switch on your transmitter and make sure that the
trigger button is on the locking position.
Place the “Remove Befor Flight“ in the arming rod
hole.
Power up the receiver or the stand-alone trigger
module. Check the binding / radio pairing.
Disconnect the receiver from the battery or from the
stand-alone trigger module.
Remove the“Remove Before Flight” pin. Switch o the transmitter.
In order to guarantee the kit is eciently operating and for an optimal lifespan, we recommend you to make
the following safety inspections and the following maintenance operations:
Parts Inspections periodicity Actions
- Servomotor 20 deployments Check the good working without
the pin. No sprocket is dammaged.
Replace if necessary.
- Piston line 10 deployments Preventive replacement.
- Piston line 1 deployment Visual vericiation of non rupture.
- Parachute 1 deployment Make a folding.
- Parachute 50 deployments Check the good condition of the lines
and fabrics.
- Parachute 100 deployments Send it to our workshop for a com-
plete inspection.
- Parachute 200 deployments Preventive replacement.
- Parachute 2 months If the parachute is not used for a 2
months period, make an unfolding
and a complete folding.
- Spring 50 deployments or 1 year Preventive replacement.
- Tube 1 deployment Check the tube, the base must not be
detach from the tube.
These operations can be done at our workshop.
Please contact your Opale Parachutes team.
Maintenance
Installation on the DJI Matrice M200 / M210
Here is a an overview of the parts required for the
adapter of the DJI Matrice M200 / M210
Insert the 2 side parts and x them with 2 x M3-8 CHC
screw and 2 x M3 nuts.
Insert the tub holder parts and place the adapter on
the upper arm of the Matrice M200 /M210 landing
gear. Use 4 x CHC M3-35 with 4 x M3 nuts.
Fix the ST80 on the adpater.
Use 3 x CHC M3-12 screws. Place between the adapt-
er and the ST80 a plastic spacer. And x the whole
thing with M3 nuts.
Do the same operation on the other side.
Then place the xation strap of the parachute on the
landing gear support.
Make sure that you have the same servo settings on
both ST80. You will be able to use a Y power cable to
simultaneously deploy both parachutes.
Installation on the DJI Matrice M200 / M210
14 15
