Optoma hdcast pro Quick manual

Basic user manual
HDCast Pro

Copyright
© Copyright 2015. This publication, including all photographs,
illustrations and software, is protected under international copyright
laws, with all rights reserved. Neither this manual, nor any of the
material contained herein, may be reproduced without written
consent of the author.
Disclaimer
The information in this document is subject to change without notice.
The manufacturer makes no representations or warranties with
respect to the contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular purpose.
The manufacturer reserves the right to revise this publication and to
make changes from time to time in the content hereof without
obligation of the manufacturer to notify any person of such revision or
changes.
Trademarks
Optoma and its logo is a registered trademark of Optoma
Corporation. Optoma Europe Ltd is the licensee of the registered
trademark. Android is a registered trademark of Google Inc. Windows
is a registered trademark of Microsoft Corporation in the United
States and/or other countries. OS X is registered trademarks of
Apple Inc. iOS is a trademark or registered trademark of Cisco in the
U.S. and other countries and is used under license. HDMI, the HDMI
Logo, and High-Definition Multimedia Interface are trademarks or
registered trademarks of HDMI Licensing LLC in the United States
and other countries. MHL, Mobile High-Definition and the MHL logo
are trademarks or registered trademarks of MHL, LLC.
FCC
This device has been tested and found to comply with the limits for a
Class B digital device pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful

interference in a residential installation. This device generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference
to radio or television reception, which can be determined by turning
the device off and on is encouraged to try to correct the interference
by one or more of the following measures:
•Reorient or relocate the receiving antenna...
•Increase the separation between the device and
receiver...
•Connect the device into an outlet on a circuit different
from that to which the receiver is connected...
•Consult the dealer or an experienced radio/television
technician for help...
•
Notice:Shielded cables
All connections to other computing devices must be made using
shielded cables to maintain compliance with FCC regulations.
Caution
Changes or modifications not expressly approved by the
manufacturer could void the user's authority, which is granted by the
Federal Communications Commission, to operate this projector.
Operation Conditions
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Notice:Canadian users
This Class B digital apparatus complies with Canadian ICES-003.
Remarque l'intention des utilisateurs canadiens
Cet appareil numerique de la classe B est conforme a la norme
NMB-003 du Canada.

Declaration of conformity
•EMC Directive 2004/108/EC (including amendments).
•Low Voltage Directive 2006/95/EC.
•R & TTE Directive 1999/5/EC (if product has RF
function)
WEEE
Disposal instructions
Do not throw this electronic device into the trash when
discarding. To minimize pollution and ensure utmost
protection of the global environment, please recycle it.
Warranty
For warranty information please visit www.optoma.com

TABLE OF CONTENTS
Copyright ..…………………………………………………...……………1
Disclaimer………………………………………………………………….1
Trademark ...………………………………………………..…….……….1
FCC ...……………………………………………………..……………….2
Declaration of conformity ...……………………………..……………….3
WEEE ......……………………………………………………………..…..3
Warranty ..……………………………………………………………..…..3
Setup …………………………………………………………………..…..4

Step 1
Connect the HDCast Pro to the projector
a
b
c

Step 2
Turn on projector and select HDMI source
a
b
The following screen will be displayed

Step 3
Download and install the HDCast Pro app
Android / iOS / Windows / OSX
www.optoma.com
Step 4
Connect to wireless SSID (HDCastPro_xxxxxxxx)
Note: You may be asked to enter a password. The password can be
found in the top right corner of the projector screen
HDCastPro_xxxxxxxx

Step 5
a. Open the app
b. Select HDCast Pro
c. Connect to HDCastPro_xxxxxxxx

Android / iOS interface