Orange Amps Fur Coat User manual

IMPORTANT
The Fur Coat can be powered by 9 or 12V DC. A regulated
DC power supply fitted with a centre negative plug
(2.1mm) must   be   used  . Running at 12V will increase the
headroom and the output volume available.
9V Battery Operation
To replace the battery, unfasten the four screws on the
base and secure the new battery in the battery clip,
making sure to observe the battery’s polarity (+ / -).
The Fur Coat is a fully controllable old school fuzz pedal
inspired by the Foxx Tone Machine. Always place it first in
the signal chain with no buffer as a passive guitar pickup
as part of the circuit. When running the Fur Coat into the
clean channel, the EQ should be set to halfway or lower.
If into the dirty channel, set it higher.
If the octave level is set to less than flat out, the octave
can be controlled using the guitar volume.
Depending on your location, fuzz pedals can pick up radio
signals, this is completely normal.
FUR COAT USER MANUAL
ORANGE AMPS
LONDON • ENGLAND
 “VOICE OF THE WORLD™
EST. 1968 

VOLUME
Output level
FUZZ
Controls the level of fuzz gain
EQ
Sculpts the tone produced
OCTAVE
      Adds upper octave to the tone
 INPUT
Connect guitar here
OUT
Out to amp or next pedal
OCTAVE
Activates octave control
FUZZ
Activates fuzz control

9-12V DC
INPUT

Ensure only a centre negative adaptor is
used