Otto OTRLGTST User manual

Model: OTRLGTST
INSTRUCTION MANUAL
10" Ring Light Tripod Kit
+
ON/OFF
1/7

Product Specifications
Model:
Officeworks Product Code:
3200-6000K
62-100mm
80-180cm
5V 1A
12.5W (Max)
USB 2.0 cable (included)
Safety and General Information
1. Moist or underwater condition.
2. Do not use chemical solvent on
cleaning this product.
3. Do not subject the device to liquid
or attempt to disassemble the
device.
4. Do not use this product in an
aircraft.
5. Do not expose the device to direct
sunlight, heat or flame.
\
Light diameter:
Light temperature:
:
Phone holder width:
Tripod height:
Rated input:
Rated power:
Power supply:
Please read all safety instructions before using this product.
Improper use of this product may result in damage to this or
attached products. To ensure the product works well, please
never use the product in the following condition:
STORE THE UNIT IN A DRY PLACE
WHEN NOT IN USE.
USE SHARP METAL OBJECTS.
·
·
·
·
ONLY CONNECT USB CORD TO
POWER SUPPLY WITH 1A MAX .
HANDLE WITH CARE, DO NOT
INDOOR USE ONLY.
2/7

Assembly Instructions
Step 1: Prepare the folded tripod stand.
Step 2: Loosen the screw knob anticlockwise.
Step 3: Use both hands to pull the stand legs open.
3/7

3
Step 4: Adjust the stand legs then tighten the screw knob.
Step 5: Loosen the screw knobs on the middle pole and the top
pole.
Step 6: Pull the poles up to the height (max 1. m) you want and
tighten the knobs.
4/7

4/7
4/7
Step 7: Install the tripod ball-head on the tripod and tighten it.
Step 8: Install the ring light and the phone holder on the
head and tighten it.
Step 9: Loosen the ball-head knob to adjust the right light then
tighten, assembly completed.

Function
On/off
Increase brightness
Light mode
Decrease brightness
Phone holder
LED light
Tripod
Main pole
Ball head
+
1
11
10
9
8
7
6
5
1
2
3
4
2
3
4
5
6
7
8
9
11
&
10 ocking device
ON/OFF
The height is adjustable, loosen the locking device to adjust
it and tighten whenever needed.
Packing Accessories:
0 LED Ring Light with cable x 1
Phone x 1
Phone cradle holder x 1
Connector piece x 1
Tripod x 1
(Smart phone device and power adaptor are not included.)

6
Product Warranty
— Valid for Australian Customers Only
OFFICEWORKS LTD
236-262EASTBOUNDARYROAD
EAST BENTLEIGH VIC 3165AUSTRALIA
MADE IN CHINA
Officeworks Ltd warrants that this product will be free from defects and
work as intended for 3 years from the date of purchase by the original
customer.
If the product has any defects or does not work as specified during the
Warranty Period, Officeworks will, at its election and at its expense, repair
or replace the product.
This warranty does not apply:
• to cosmetic damage;
• to damage caused by consumables used in connection with the
product ;
• where the product has not been used in accordance with all provided
instructions;
• to damage arising from fair wear and tear;
• where the product has not been subject to reasonable use;
• where the product has been intentionally or negligently damaged;
and/or
• if the customer has attempted to repair the product.
To make a claim under this warranty, please return your product with your
receipt or proof of purchase to your nearest Officeworks store or contact
1300 633 423.
This warranty is provided in addition to any rights you may be entitled to
under the Competition & Consumer Act 2010. Our goods come with
guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and
compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods
fail to be of acceptable quality and the failure does not amount to a major failure.