Outdoor GreatRoom Company LYNDALE SWIVEL ROCKER LSR-CA User manual

LYNDALE SWIVEL ROCKER
Assembly Instructions For:
LSR-CA & LSR-CS
IMPORTANT ASSEMBLY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
When using the furnishing, basic precautions should always be followed, including the
following:
Read all instructions before assembling or using the Lyndale Swivel Rocker.
Use the furnishing only for its intended use as described in these instructions.
42479 REV A 09.06.17

INCLUDED PARTS
ASSEMBLY INSTRUCTIONS
2. Place the chair seat (A) upside down on a non-abrasive flat surface.
1. Remove all protective material carefully. Avoid cutting the surface
of the furniture while removing the packaging material.
3. Align the holes on the support bar (M) on the underside of the chair
seat with the holes on the spring plates attached to the t-rocker. Make
sure the arrow labels on the rocker mechanism and chair support bar are
facing the same direction—towards the front of the chair.
1.
Check for damage. Do not use damaged components.
Warning: Improper assembly may result in serious personal injury.
F- Bolt 5/16 * 1.575” (8X)
I- Metal Plate (8X)
H- Flat Washer (16X)
J–Nut (8X)
G-Lock Washer (8X)
L- Nut Cover (8X)
K- Bolt Cover (8X)
A- Chair Seat (2X)
B- Chair Base (2X)
M- Support Bar (2X)
REQUIRED TOOLS
• Utility Knife
To cut and remove packaging
• Wrench
For tightening components on chair
42479 REV A 09.06.17
D- Back Cushion (2x)
• LSR-CS-RC
• LSR-CA-RC
C- Seat Cushion (2x)
• LSR-CS-RC
• LSR-CA-RC

5. Once all the nuts and bolts are in place, securely tighten all the
bolts (F) and nuts (J), including the ones at the front part on the rocker.
Cover all nuts (J) and bolts (F) with nut cover (L) and bolt cover (K).
mechanism.
4. Insert bolts (F) through flat washer (H), the metal plates (I), support
bar, spring plate and the metal plates (I) as showed in the diagram. Secure
bolts with flat washers (H), lock washers (G), and nuts (J). The support bar
and spring plate should be sandwiched in between the metal plates (I).
6. Put the seat cushion (C) and back cushion (D) (As shown below).
8. Test the swivel rocker gently. If the rocker does not rock
properly, double check the assembly procedure.
Your Lyndale Chairs include either Sunbrella™ Cast Ash or Cast Slate fabric. There is
typically a break in period to achieve maximum comfort. If you wish to accelerate that
period, you can place the cushions on a clean, dry surface and walk on them.
For general cleaning, you can brush of any dirt or debris and clean with a mild solution of of
water and soap. Rinse thoroughly to remove all soap residue and air dry. For more
detailed care, cleaning and stain removal, please visit www.sunbrella.com.
*Optional lumbar pillows available: Part Number –LSR-CPL*
42479 REV A 09.06.17
7. Secure back cushion (D) to chair frame (A) with the use of Velcro
straps.

14400 Southcross Drive West •Suite 100 •Burnsville, MN 55306
Toll Free: 1-866-303-4028 •[e-mail]