Outwater Industries, Inc. assumes no liability for improper installation. Page 4
+The Adapter mounts on the pull-out as per drawing 4,
1a and according to the hole locations 4b.
+The following adjustments should already be pre-adjusted:
Please check before inserting pull-out unit that the safety clip on
the U-Prole of the Top Guide is open (Illustration A) and the
height-adjustment is all the way down (Illustration B).
Also check that the adapter set screws are backed out far enough
(Illustration B).
+Insert the slide-out unit all the way to the end stop.
+Close safety-clip on the U-Prole of the Top Guide (Illustration A).
Tighten the adapter set screws at the same time adjusting the side
to side position (Illustration B).
+Adjust the height position on the OI-777 as per (Illustration B).
MOUNTING
MOUNTING
HOLE LOCATIONS
