OXO Good Grips User manual

Expandable Wall-Mounted Organizer
MOUNTING INSTRUCTIONS

A
Mounting
Plate
F
CamLock™
Holders x4
G
Hooks x4
B
Aluminum
Rail
H
Screws x4
I
Drywall
Anchors x4
D
Inner Rail
Endcap
E
Outer Rail
Endcap
C
Support
Plate
INCLUDES

1”
1”
1”
Determine a location for the organizer. Please
note that the aluminum rail (B) extends past the
mounting plate (A) so adequate clearance is
necessary.
B
A
Mark hole on the left side of mounting plate (A).
Level mounting plate using built-in level and mark
hole on the right side of mounting plate (A).
1
A
If not mounting directly into a stud, use drywall
anchors (I). TIP: Put a starter hole in the wall for
anchor to go in easily.
DRYWALL OPTION
I
x2

Line up mounting plate (A) with pencil marks.
Arrows on mounting plate should be in up
position. Fasten the mounting securely to wall
using screws (H) provided.
2
H
A
H
A
11
2
2
Attach aluminum rail (B) to mounting plate (A)
by hooking from top and pushing until it clicks
in place.
3
B
A
2” min
Slide outer rail (B) to desired length. Be sure to
maintain a minimum 2" overlap between the
inner and outer rails. Mark location on wall.
B
4
OVER

Fasten support plate (C) to mounting surface
using screws (H) provided. Slide aluminum rail
(B) back into place.
6
C
B
H
1”
Slide outer rail (B) back and insert support plate
(C) into outer rail (B). Support plate (C) must
be installed at least 1" from desired length.
C
B
B
5
If not mounting directly into a stud, use drywall
anchors (I). TIP: Put a starter hole in the wall
for anchor to go in easily.
DRYWALL OPTION
B
I

Slide CamLock™holders (F) onto aluminum rail (B).
7
Side View
F x4
B
1
2
Hooks (G) attach from top of rail and snap into
place.
8
x4 G
Insert endcaps (D & E).
9
D
E

1
2
Lift hooks (G) from bottom to remove or adjust
their positions. Note: Camlock™holders (F) can
only be removed by sliding them off of the rails.
REMOVING/ADJUSTING HOOKS
G
www.oxo.com