Panacom T-i7XG User manual

T-i7XG User Manual
T-i7XG Manual del Usuario

Pg. 2
Thanks for purchasing 7” TABLET T-i7XG PANACOM.
Please read this manual carefully before using this Tablet.
DO NOT ALLOW WATER OR FOREIGN OBJECTS TO ENTER
THE UNIT.
I. NOTE:
1. Avoid the unit being dropped. Avoid the display been shake
seriously, or the display will be damaged or unusual.
2. Do not use metal object to touch the device to prevent it from
short circuit.
3. Please backup your data in case your important data is lost,
especially before you upgrade the rmware. The company will
not take charge in any loss that caused by lost of data.
4. Do not disassemble. Do not wipe the surface of the unit by
alcohol, thinner or benzene.
5. Do not disconnect the unit while it is formatting or uploading/
downloading, or the procedures may lead to errors
6. We do not take responsibility to the ash damage caused by
product broken, repair or other reasons. Please operate strictly
as per the user guide.
7. Avoid water or foreign objects enter the unit.
8. Do not use the unit in places that are extremely hot, cold, dusty,
or humid.
9. Specications are subject to change and improvement without
notice

Pg. 3
II. INTRODUCTION OF COVER:
1. Back Camera
2. Micro USB interface
3. HDMI interface
4. Reset
5. Earphone Jack
6. Volume+, Volume –
7. Power on/off
8. MIC
9. Front Camera
10. TF-CARD interface
11. Loudspeaker
9
6
5
4
1
2
3
8
7
10 11

Pg. 4
III. OPERATION INSTRUCTION
1. Basic Operation
1.1. Power on/Power off
Power on:
Press and hold the power switch for 5 seconds; the unit displays the
start-up logo and enters the working mode.
Power off:
Press and hold the power switch for 3 seconds to turn the unit off.
Sleep:
While the device is at working status, press the power switch, it
enters the sleeping mode, and the screen will be off then. Press the
power switch again, it shift to the normal mode. You may use this
function when you don’t’ use the device temporary to save power.
1.2. Charging
When the device prompts low battery, please charge it by provided
charger.
Note:
To improve the longevity of the battery, you may charge for another
15 minutes after it prompts the battery is full.
1.3. Main menu
Click the icon in the main interface, the main menu is
appeared. It including the system setting, music playback, video
playback, web browser and other applications you installed in the
main menu.
2. Settings
Click “ ” in the main interface to enter the setting interface.
Click the corresponding setting items to operate.

Pg. 5
2.1. Date and Time Setting
Click “Date & Time” in the setting interface to set the date and time.
You may set the date, time zone, time, time format and date format
etc. in the menu.

Pg. 6
2.2. Brightness
Select “Display” in the setting interface. Click “Brightness” to
enter, and slide the bar to adjust the brightness.
3. Wi-Fi connection
Click “Settings” in the main interface and click “Wireless &
network” to enter the wireless and network setting interface. Click
Wi-Fi to turn on the WIFI. Click Wi-Fi setting to set and manage
wireless access.

Pg. 7
Click “Network Notication”, it lists the open network it searched.
Click the name of the network; it pops up the setting window. You
may connect it to WIFI according to the prompts. You need to
input the user name and password if networks are encrypted.
4. Explorer to install App
4.1 Install
There are many ways to install applications under Android, such
as via USB, by third party program. We introduce installation by
Apps Installer here.
Click the “APKInstaller” in the main interface to enter the “install
and manage” interface.
Select the APK le you want and enter the application installation
interface. Click “Install” to install the application automatically.
After installation, it prompts “Open” and “Finish”. Click “Open” to
open the application. Click “Finish” to exit.
4.2 Uninstall
You may use the corresponding third party software management
tool or the installed application management software of the
device to install applications.
Select “Setting/Applications/Manage applications” to select the
installed applications and check the attribute of it or uninstall it.
5. Connect to internet
5.1. After connecting with WIFI, open the browser and input the
web address, you can browse the web then.
5.2. Click the icon to enter the bookmark to view the browse
history. Click the web page you want to open it.
To save the web page into bookmark, you may click to enter
and click “add” to save it.

Pg. 8
6. Audio and video playback
6.1. Audio playback
Click the “Music” in the main menu to enter the audio playback
interface. It lists the audio les in the device, and you may click the
le name to play it. in the audio playing interface, click the icons to
play/pause/ increase volume/ decrease voluem/ FF/ REW….

Pg. 9
6.2. Video Playback
Click the “Gallery or Video” in the main menu to enter the video playback
interface. It lists the video les in the device, and you may click the
le name to play it. in the video playing interface, touch the screen to
pop-up the operation icons and click the icons to play/pause/ increase
volume/ decrease volume/ skip to next le/skip to previous le….

Pg. 10
7. Picture viewing
Click “2160P(Gallery)” in the main menu to enter the picture folder list.
Select and click the folder you want to enter, it displays the . click the
thumbnail of the picture to view it.
Touch the screen to pop-up the operation icons while viewing the
picture, you may zoom in/zoom out/ skip to next picture/skip to
previous picture/ rotate/ delete the picture…

Pg. 11
8. 3G DONGLE
The device supports external 3G Dongle, connect the 3G dongle to the
device via the external transfer cable, after the dongle indicator lights,
you may use the 3G network normally.
9. Camera
Click “Camera” in the main interface.

Pg. 12
9.1 Camera
If the cursur is at postion, the device is at Camera mode.
Click to take picture.
Click to enter the setting interface
Click to set the scene mode, Picture size, Picture quality, and
color effect.
Click to select back or front camera.
9.2 DV
Click to enter the mode select interface
If the cursur is at position, the device is at DV mode.
Click to start recording.
Click to set the color effect or restore to default settings.
10. Connect with external device
10.1. Connect with PC
Connect the device with the PC via the USB cable. The PC appears
two new disk symbols after connected successfully. One is the TF
card, and the other is the built-in ash.

Pg. 13

Pg. 14
10.2. Use of OTG and USB host
It supports the movable device with FAT32 format, such as U disk and
MP3.
Connect the movable device to the MID. (Note: only OTG could
support USB mouse and keyboard, USB HOST only support USB2.0
High speed device)
10.3. Applications
For convenient usage, we installed some third party software in the
MID. For detailed operation methods, please check the corresponding
instruction. Some of the software may be able to be used in some area
because of network service.
IV. TROUBLESHOOTING
1. What if the device is abnormal during operation?
Answer:
1). Reboot the device to see if it works OK.
2). Charge the device by the charger to activate the battery.
Makesure it has power before you operate it.
3). It is suggested to upgrade the OS of the device by
professional.

Pg. 15
2. Why the standby time is so short sometimes?
Answer: the use time of the battery is all depend on the temperature
and use instance. If the temperature is too high or too low, the use
time of the battery might be effected. It is suggest using the device in
normal temperature.
The using time is also affected by increased volume and frequently
operation.
V. SPECIFICATIONS
Item T-i7XG
Dimension 190x108x10.5mm
Display 7” 1024 x 600 TFT touch panel
OS Android 5.0
Capacity 8GB
External Capacity TF card, up to 32GB
Audio MP3,WMA,FLAC,APP,OGG.
(support all audio formats)
Video MINI HDMI, MPEG4-SP, ASP, DIVX, WMV, RMVB,
H.264/1080P (support all video formats)
Function WIFI, BT, HDMI,GPS, FM transmitter
Language Multi-language
USB USB 2.0 high speed
OTG Support
Temperature -20oC to 60oC
Battery 2400MA poly-lithium battery
RAM 1 GB
Camera front 0.3M + back 2M camera
Processor MTK 8127 Quad CoreCortex A7 1.3GHz
Note: The pictures list in the manual are for reference only!
The design and the specication of the unit are subject to change without
notice.

Pg. 17
INTERNATIONAL WARRANTY
Terms and Conditions
1. PANACOM warrants the operation of this product to be
free from any manufacturing and/or material defect for a pe-
riod of 6 months from the date of purchase by the user.
2. This warranty is limited to the repair and/or replacement of
this product, according to our own criterion, free of charge
within the stipulated term and it does not extend to conse-
quential or incidental damages to other products that may be
used with this unit.
3. The warranty shall be voided in the following cases: a)
repair or attempt to repair by third parties not authorized by
the company. b) in case of performing any type of cut in con-
nection cables, plugs, connectors, or other adapters differ-
ent from the original ones provided by the company.
4. To make this warranty effective, you shall contact the Au-
thorized Service Center of your country and they shall carry
out the pertinent procedure; this information is available at
www.panacom.com. In order to start the necessary proce-
dure to get the warranty, you shall hand in the Original Pur-
chase Invoice where the purchase date, dealer name and
product identication shall be stated clearly.
5. Transportation, freight, stay and/or insurance expenses, if
any, are not covered by this warranty.
To ask for technical support of this product in Argentina call 0810-
888-7262

Pg. 18
No permita que agua o materias extraños entren en el equipo.
I. NOTA:
1. Evitar que la unidad se caiga, se sacuda o dañe en forma
inusual.
2. No usar metal para tocar el dispositivo para evitar que se pro-
duzca un cortocircuito.
3. Haga copia de seguridad de sus datos en caso de que los
datos importantes se pierdan, especialmente antes de actua-
lizar el rmware. La empresa no se hará cargo de ninguna
pérdida de datos .
4. No desmonte. No limpie la supercie de la unidad con alco-
hol, disolventes o benceno.
5. No desconecte la unidad mientras se está formateando o en
carga/descarga, o los procedimientos pueden dar lugar a
errores
6. Nosotros no nos hacemos responsables de los daños causa-
dos por el mal uso del producto y reparación no autorizada.
Por favor, operar estrictamente de acuerdo con el manual de
usuario.
7. Evitar el agua u objetos extraños en la unidad.
8. No utilice la unidad en lugares que sean muy calientes, fríos,
polvorientos o húmedos.
9. Las especicaciones están sujetas a cambios y mejoras sin
previo aviso.
Gracias por la compra de su 7” TABLET T-i7XG PANACOM.
Por favor lea este manual cuidadosamente antes de utilizar esta Tablet
para seguir las mejores pautas tendientes a ofrecer el mejor servicio

Pg. 19
9
6
5
4
1
2
3
8
7
10 11
II . INTRODUCCIÓN DE LA CUBIERTA:
1. Cámara trasera
2. Puerto Micro USB
3. Puerto HDMI
4. Restablecer
5. Toma de auriculares
6. Volumen +, volumen -
7. Encendido / apagado
8. MIC
9. Cámara frontal
10. Puerto TF-CARD
11. Altavoz

Pg. 20
III . INSTRUCCIÓN DE LA OPERACIÓN
1 . Funcionamiento básico
1.1 . Encendido / apagado de alimentación
Encendido:
Pulse y mantenga pulsado el interruptor de encendido durante 5 se-
gundos; la unidad muestra el logotipo de la puesta en marcha y entra
en el modo de trabajo.
Apagado:
Mantenga pulsado el botón de encendido durante 3 segundos para
apagar la unidad.
Modo Sleep:
Mientras que el dispositivo se encuentra en estado de trabajo, pulse el
interruptor principal, se entra en el modo de sleep y la pantalla se apa-
gará a continuación. Pulse el botón de encendido de nuevo, cambia
al modo normal. Usted puede utilizar esta función cuando no utiliza el
dispositivo temporalmente, para ahorrar energía.
1.2 . carga
Cuando el dispositivo indica batería baja, cárguela siempre con el car-
gador.
Nota:
Para mejorar la longevidad de la batería, cargue por otros 15 minutos
después de que la batería está llena.
1.3 . menú Principal
Haga clic en el icono en el menú principal. Incluye la congura-
ción del sistema, la reproducción de música, reproducción de vídeo, el
navegador web y otras aplicaciones instaladas en el menú principal.
2. Configuración
Haga clic en en el menú principal para entrar en la interfaz de