SUP in a sunny location when not in use. Sunlight will harm your paddle board if exposed for extended
periods of time.
When a ParadisePad SUP is inflated to 15 psi it can burst when left in the sun to expand. This is due to
the sun's heat can increase the pressure inside the board beyond its limits. This burst from sitting under
pressure in the sun are not covered under warranty as this is not a manufacturing defect.
STORAGE AND BOARD CARE
●Always store your SUP in a cool dry location out of reach of direct sunlight
●Remove the fin before rolling up the SUP. Roll the board starting from the nose with the deck
pad on the inside and the fins will be on the outside
●When storing your board for prolonged periods in deflated, it is best to keep it loosely rolled
or unrolled completely
●Before storing , rinse off with fresh water and let it dry completely to prevent mildew buildup.
Most dirt can be removed with mild soap and fresh water
●Fins might bend during transportation. Fins can easily be straightened using either natural
sunlight heat or the heat from a hair dryer
LEAK DETECTION AND REPAIR
●If you are losing air pressure not caused by colder temperatures, check the board for leaks
starting with the valve. A leaking valve is rare. We have supplied in the repair kit a valve
wrench if the valve is loose. We could supply a replacement valve if it is found to be defective
●Small leaks can be easily found and repaired. Spray all around the board with a mix of
liquid soap and water until air bubbles become visible
●The ParadisePad SUP comes with a repair kit. Once a leak is found deflate the board and cut a
round piece of repair material large enough to overlap the leak by 2". Round corners of the
patch are less likely to snag. Apply the adhesive to the bottom of the patch and on the SUP
air leak area. Allow adhesive to become tacky then apply the patch. This is a contact adhesive
and once the surfaces touch, you cannot reposition the patch, so be careful to align it before
bonding the surfaces together. Roll the patch onto the board surface to prevent a air bubble.
Thoroughly go over the surface of the patch with a roller, edge of the valve wrench to
apply pressure and ensure a solid bond. Apply a weighted object to apply pressure to the
area for 12 hours. Do not apply full air pressure to the SUP for 24 hours
LIMITED WARRANTY
ParadisePad provides a 2 year limited warranty on all SUP products and warrants that these products
are free of defects in materials and workmanship for the period of 2 years of the original owner of the
SUP. After inspection, we find that this SUP failed due to a covered defect, it will be repaired or replaced
at our option and you will need to cover shipping charges from the consumer to ParadisePad.
This warranty period for the board does not cover:
●Normal wear & tear including scratches, fading, cuts, tears or commercial use including rental
●Damage caused by abuse or failure to perform normal maintenance
●Damage caused Modifications or alterations
