Paramount Fitness clear o3 User manual

ISSUE SOLUTION
No air bubbles entering system or pool Clean filter then adjust airflow needle
valve
Filter empties and pump loses prime Replace check valve fitting at strainer pot
Light bulb does not light
Check power to the ClearO3, if you have
power and the bulb still doesn’t light up,
turn off the power and replace the bulb.
295 East Corporate Place • Suite 100 • Chandler, AZ 85225
Toll Free: 1.800.621.5886 • Phone: [phone]
Fax: [phone]
[email protected] • www.1Paramount.com
004-027-7849-00 REV040816
US and Foreign patents and patents pending see www.1paramount.com/about/patents/
BULB REPLACEMENT
INSTALLATION MANUAL
NOTE: Ozone production from direct UV light will decline over time. UV bulbs continue
to illuminate after they stop producing an effective level of ozone to clean your pool
water. To make sure your pool continues to receive all the benefits of ozone, Paramount
recommends that you replace your bulb every three (3) years or 13,000 operating hours.
Turn off power at main source before making any electrical
connections or servicing the unit.
UV light produced by this unit is harmful to the eyes and may cause blindness! Do
not look directly at a lit bulb!
WARNING
The ballast resets instantly on restoration of power. When the lamp restarts, it will light
up orange first then turn blue in about 10 seconds. If the UV bulb still does not illuminate
1-800-627-5886 and ask for customer service for further instructions.
TROUBLESHOOTING & SERVICE

REPLACING UV BULB
DO NOT TOUCH THE GLASS, HANDLE BY CERAMIC ENDS OF BULB
Turn the power off to filtration system
pump at circuit breaker. Remove three
screws in left end side cap labeled
“electrical connections”.
Remove and throw away the old
gasket. Make sure new gasket is
in place on replacement bulb. Align
with key and slide into hole until bulb is
completely into unit.
Press plug onto light bulb. Replace
side cap and three screws. Turn on
power to filtration system pump.
Remove side cap. Grasp light bulb plug
and pull light out about one inch.
Pull light bulb free from Clear O3 unit.Remove plug from light bulb.
Check glow tube on the left front of the Clear O3. A light blue light
indicates lamp is lit and the unit is producing ozone.
Replace
old gasket