Parmigiani Tonda GT Integrated Chronograph PF071 User manual

Tonda GT Integrated Chronograph (rose gold)
PF071

indications - TONDA GT CHRONOGRAPHE
1
4
2
3
5

3
Tonda GT Integrated Chronograph (rose gold)
PF071
INDICATIONS
1. Hours, minutes, seconds counter
2. Date
3. Chronograph seconds
4. 30-minute counter
5. 12-hour counter

remontage - TONDA GT CHRONOGRAPHE
1 3
2
counterclockwise clockwise

5
Tonda GT Integrated Chronograph (rose gold)
PF071
WINDING
Your watch automatically self-winds when you wear it. To become fully wound,
it must be worn for at least 12 hours. This may vary depending on the type
of user. If the watch is completely unwound, the crown will have to be turned
approximately 15 times; this properly activates the mechanism. Note: the
number of crown turns required to completely wind a watch varies depending
on the caliber. Winding by the crown can be done at any time. When it is
stopped due to an insufcient charge, it must be rewound. For this watch :
1. Unscrew the crown by turning it counterclockwise until it is released.
2. Turn the crown a few times clockwise to wind your watch.
3. Screw the crown back in while pressing it against the case.
Winding by the crown can be done at any time.

mise à l’heure - TONDA GT CHRONOGRAPHE
1 4
3
2
counterclockwise clockwise

7
Tonda GT Integrated Chronograph (rose gold)
PF071
SETTING THE TIME
1. Unscrew and pull the crown out two notches.
2. Turn the crown anti-clockwise to advance the hands until the date disc
(calendar) jumps (it is then midnight).
3. Turn the crown to the desired time.
4. Push the crown back to its initial position and screw it back down while
pressing it against the case.

réglage de la date - TONDA GT CHRONOGRAPH
1 2 3
counterclockwise clockwise

9
Tonda GT Integrated Chronograph (rose gold)
PF071
SETTING THE DATE
1. Unscrew and pull the crown out one notch.
2. Turn the crown clockwise to scroll to the desired date.
3. Push the crown back to its initial position and screw it back in while pressing
it against the case.
Note: do not make adjustments between 10 p.m. and 1 a.m.

chronographe - TONDA GT CHRONOGRAPH
A
B

11
Tonda GT Integrated Chronograph (rose gold)
PF071
CHRONOGRAPH
Description of the push-buttons
A.Start and stop push-button
B.Reset push-button
1. Pressing push-button A once starts the chronograph.
2. A second press on push-button A stops the chronograph. To resume timing,
press button A again.
3. When timing is stopped, pressing push-button B returns the chronograph
hand and the counters to zero.
Note: a complete reset can only be done when the chronograph is stopped.

PARMIGIANI.COM