Portable Rugged IPX6
Waterproof Bluetooth Speaker
User’s Manual
Introduction:
PB252B
1.ON/OFF /Play/Pause/Phone button
2. Previous/Volume –
3.Next/Volume +
4.Status LED
6.Micro USB Charging Port / AUX Input Port
Included:
1.Speaker
2.USB Micro Charging Cable
3.3.5mm Audio Cable
4. User Manual
Specifications:
Supported Profiles: A2DP, HFP, AVRCP
Bluetooth Range: 33ft (10m)
Dimensions: 185 mm x 25 mm x 82mm
Begin Streaming Music
Press to start playing music
Press and Hold 2 seconds to play the next track
Press and Hold 2 seconds to play previous track
Press button or to set the volume level
Making and Receiving Phone Calls
When the unit is connected and paired to your device,
the unit allows you to make or receive phone calls with its
built-in microphone.
Press to accept a calll, to
end a call press .
To reject a call, press and hold for 2seconds
Aux-In Mode
Plug in the supplied 3.5mm to micro USB cable. The micro USB
connector will plug into your BT speaker, the 3.5mm connector is
for the input audio source. The Blue LED will flash slowly when in
Aux mode. Please note music selection and volume can’t be
controlled by your device in AUX mode.
Thank you for choosing the PB252B as your source for entertainment!
You can use this item with iPads, iPhones, iPods and many types of
smartphones to stream music and enjoy handsfree calling. In order to
get the best results when using the device, please read this manual
first before using.
Description:
2 1 3
5 4
6
Battery: Li-Ion 3.7V, 2000 mAh
Charging: DC 5V @ 500 mA
Weight: 320g
Operation:
Powering On
Press and Hold ON/OFF button 2 seconds to power ON, the
Blue LED will start to flash rapidly.
If an AUX (3.5 mm) cable is connected the Blue LED will slowly
blink indicating unit is in AUX-In mode.
Powering Off
Bluetooth mode: Press and hold ON/OFF button for 2
seconds to disconnect the Bluetooth, then press and hold
ON/OFF button again to power off the speaker.
AUX mode: Press and hold ON/OFF button for 2
seconds to power off.
Bluetooth Mode
Pairing
The unit will automatically go into pairing mode when it is
powered ON.
Go into your Bluetooth device settings menu and look for
PB252B.
After the unit has paired and connected, it will re-connect
automatically when the unit is powered on and the device
is in range.
*Auto power off after 10 minutes inactivity.
