Patio Premier 207004 User manual

Please do not return this product to the retailer.
If you are missing or have damaged parts please email
[email protected] Or Call 877-477-2264
For Manuals, Replacement Parts or Customer Service visit:
www.ezreplacement.com
This product is intended for
This product can expose you to lead, a chemical known to the state of
California to cause cancer, birth defects and/or other reproductive harm.
For more information go to www.p65warnings.ca.gov/product
residential, non-commercial use.
MADE IN CHINA
©2020 J & J Global, LLC
Distributed By:
J & J Global, LLC
Irving, TX 75038

3pc Bistro Set
Sku: 207004, 207005, 207006
Please keep this instruction manual for future reference
Read the instructions and precautions before use of this product
For warranty information, please refer to the back page of
this instruction manual.
Most metal outdoor furniture is finished with paint, varnish, or powder coating to
prevent rust. While aluminum doesn’t rust–it can oxidize (causes pitting & dulls the
finish). So maintaining your furniture will extend its life & make it easier to clean.
· Wash all frames with a solution of mild soap (like dish soap) and water.
· Rinse with clean water and dry with a soft absorbent cloth towel to remove buildup
of dirt particles.
· DO NOT clean with abrasive materials of solvents to avoid scratching or damaging
your set.
· Frames can be treated with a liquid wax for maximum protection against UV rays
and/or salty, damp air.
· Store furniture in an upright position to prevent water building up in frames, as this
will cause corrosion and freeze damage in cold climates.
· Consider covering your furniture when not in use for long periods of time (and
during bouts of inclement weather).
Care Instructions

Package Contents
3Tighten all fasteners.
AChair Back
x2
BChair Seat
x2
CChair Leg
x8
DTable Top
x1
GStud M8 x 30
x26
HBolt M8 x 30
x3
IM8 Washer
x29
JM8 Nut
x29
ETable Leg
x3
FTable Center Brace
x1
Hardware Contents

1Thread studs (G) into holes on bottom of chair back (A). Insert studs (G) on chair back
(A) through holes on chair seat (B) top side.
With chair back (A) in place, thread studs in bottom holes of chair seat (B) next to studs
of chair back. Insert chair leg (C) onto chair seat (B) studs, connecting the chair back,
seat and leg.
Secure leg, seat and back with washers (I) and nuts (J).
Attach remaining legs, repeat step 2 and step 3.
Assembly second chair in same manner, repeat steps 1 - 4.
2Position table top (D) upside down on a clean surface. Thread studs (G) into holes on
bottom of table top (D).
Place the holes at top of leg (E) over threaded studs (G) on bottom of table top (D).
Secure using washers (I) nuts (J). Do not over tighten fasteners.
Attach remaining legs, repeat step 7 and step 8.
Position table right side up.
Place table center brace (F) on top of tabs on table leg (E) and align holes.
Insert bolt (H) through top of table center brace (F) and table leg tab. Secure with
washer (I) and nut (J).
A
B
C
G
G
J
I
CAUTION: DO NOT over tighten fasteners
!
CAUTION: DO NOT over tighten fasteners
!
D
E
E
G
I
J
E
I
H
J
F
F