Fig. 6
When making height adjustments, use one hand to
support the tube while using your other hand to
control the tension of the wing nut/wing bolt to
prevent the tube from slipping and pinching fingers
that may be in the way.
When folding the tripod legs, be careful not to pinch
your fingers between the legs and the stand.
When handling tubular hardware do not put your
fingers into the tubes to prevent injury to your fingers.
Test the stability of the stand before use. If needed, try
one or combinations of the suggestions below until
the stand is sufficiently stable.
• Adjust the length of the boom arm.
• Change the direction of the boom arm.
• Shift the weight of the load.
• Open the tripod legs as wide as possible.
• Orient one leg in the same direction as the boom.
Before use, check to ensure all Wing Bolts, Wing Nuts,
Bolts, and Screws on the Cymbal Holders are tight
and secure.
WingLoc
Pearl’s patented WingLoc's quick release design makes
attaching and removing cymbals quick and easy.
Reversible Seat Cup
The Seat Cup is reversible and can be set to Float, to allow
cymbals to move freely, when set in the position shown in
(Fig.5-A) or it can Lock, to prevent rattle in recording
situations, when set in the position shown in (Fig.5-B).
Reversible Cymbal Washer
The B-1030/B-1030C/C-1030 stands are equipped with
Reversible Cymbal Washers with a Felt side and Foam
side. With the Foam side against the cymbal, a bright,
clear sound with long sustain is achieved. The Felt side
gives a warmer and softer sound. Mix and match the top
and bottom Reversible Cymbal Washers to find the sound
you like best (Fig.6).
Float
Fig. 5-A
Lock
Fig. 5-B
To remove the WingLoc, pull the
wings apart and lift the WingLoc
straight up (Fig.1).
To attach, keep the
wings open and place
the WingLoc and the
Upper Cymbal Washer
over the Cymbal Post as
shown (Fig.2).
To adjust, snap either
one of the wings upward
as shown in Fig.3 and
rotate the WingLoc until
the desired tightness /
looseness of the cymbal
is achieved. Snap the
other wing upward
(Fig.4) to lock the
WingLoc in place.
Fig. 1
Fig. 2
Fig. 3 Fig. 4
Upper
Cymbal Washer
Cymbal Post
NOTE
・Do not force the wings closed. If you feel resistance, rotate
the WingLoc slightly to align the threads and try closing the
wings again.
・Do not tighten the WingLoc when both wings are in the
locked position to prevent wear to the threads.
・Keep the WingLoc in the locked position when transporting
to avoid breakage or loss.
https://www.pearldrum.com
Products and specifications are subject to change without notice.
Printed in China
-Nov 2020-
Foam
Felt
Combination Example
CAUTION
