Pedigree Technologies OneView AT-130 User manual

INSTALLATIONMANUAL
PedigreeTechnologies.com | Support: (701)-499-0022
Asset Tracker AT-130
Document ID: IM-AT-130
Last Updated: March 25, 2021
Pedigree Technologies recommends using a professional installer for optimal
results. Please let your Pedigree Technologies representative suggest a provider if
you need help with your hardware installations.

2
Prerequisites
PedigreeTechnologies.com | Support: (701)-499-0022
AT-130
Required Information
• Name of asset (ex: Trailer, Generator, Rolloff etc)
• Detailed information about the asset (year, make, model, VIN, license plate, etc.)
• State, area, organization, or group the asset belongs to (ex: Texas - Midland - Equipment, etc.)
• IMEI (which is the device serial number) of each device to be installed (The IMEI is found on
the back of each unit)
Required Equipment
Required Tools
Drill and assorted drill bits (to secure device)
Slotted and Philips bits (to secure device)
AT-130

PedigreeTechnologies.com | Support: (701)-499-0022
3
Installation Steps, Continued
Installation
AT-130
MOUNT TELEMATICS DEVICE
The telematics device should be mounted with machine screws, bolts or tape to the asset in the
desired location. Use locking nuts (or loctite) to prevent shaking loose. (Activate device before
mounting, see instructions on the next page.)
Before You Begin
TURN TO THE LAST PAGE - WRITE DOWN THE REQUIRED INFORMATION!!!
• DO NOT DRILL OR SCREW INTO ROLLOVER PROTECTION STRUCTURES OR FALLING
OBJECT PROTECTION STRUCTURES (ROPS/FOPS)
• DO NOT MOUNT NEAR STRONG MAGNETIC SOURCES
• Decide where to mount device.
• AT-130 can be mounted in the interior of a cab or exterior of the asset.
• Must not be fully enclosed in metal.
• Mount where device is least likely to be damaged.
• Additional hardware may be required.
AT-130

Testing / Conrmation Steps
PedigreeTechnologies.com | Support: (701)-499-0022
AT-130
FINAL STEP
Call Pedigree Technologies installation support to conrm and nalize the installation.
701-499-0022
You will be prompted for the following information during the set up process
• Device IMEI
• Name of Asset (ex. Goosneck 51)
• Make and Model
• SN/VIN #
• License plate #
ACTIVATION PIN
1. Place the AT-130 on a flat surface as shown below
2. Remove the pin from the resting location and insert it in the notch labled “Device Activation”
to activate the device reporting. If pin is not placed in the Device Activation notch, the device
will NOT start to report! NOTE: Pin is not needed after activation. Keep if desired.
3. Leave the activation pin in the device for a full 15 seconds (the pin will fall out if moved)
Wait 5 minutes after installing/activating the device before calling Pedigree Technologies
installation support. This will give the device time to send a reading.
Pin resting location
Device Activation location