PEES COMPONENTS AN423 User manual

The AN423 servo amplifier module is intended for the control of single magnet
proportional valves.
The snap-on housing enables the amplifier module to be mounted on normal carrier
rails in control cabinets. The electrical connections are via a terminal strip and 3 flat
connectors (enable input, reference voltage +10V and GND).
Four multi-turn resistors allow the adjustment of volumetric flow amplification (Imax.),
Imin jump (Imin.) and the acceleration and deceleration ramp times (ramp up and ramp
down) to be adjusted externally.
AN423 Servo Amplifier
PEES
COMPONENTS

ENABLE
Ramp
downup
Power
DC
DC
X1
1
2
6
3
CURRENT 1V/A
GND
Imax
Imin
4
5Coil
+10V REF
GND
X3
X2
COMMAND
SIGNAL
POWER
SUPPLY
-
+
-
+
AN423_310307_Rev02
AN423 Servo Amplifier
Supply voltage
Auxiliary voltage
approx. 150Hz
Inputs
Enable
24V DC (22…32V DC)
To supply an external setpoint po-
tentiometer: +10V, max. 5mA
Output current 0... 800mA
0...1600mA
0...2500mA
PWM frequency
0...10V (differential input)
Input +24V,
indication via 'Fail safe' LED
Multi-turn Imax:
Ramp up: acceleration ramp, adjus-
table in ratio 1:50
Ramp down: deceleration ramp, ad-
justable in ratio 1:50
according to version:
Current: valve current: 1V/A (10%)
resistors Imin: adjustable for magnet coil A,
up to 50% of Imax
Measuring socket
Technical data:
Subject to change without notice
www.pees-c.com