Penn Elcom Rackz Limited Credenza Wood Rack Series User manual

19” WOOD RACKS 4U – 16U
ASSEMBLY INSTRUCTIONS
Panels
A
& B
Your Kit Consists of
2 x Top/Bottom Panels
2 x Side Panels
4 x Stick-On Feet
Pilot Holes for
mounting
Rear Rails are
provided
See accessory
listings
A
D
Position panels C & D
behind the connector
blocks as shown
Using the heel of
your hand only, tap
them into place
DO NOT TIGHTEN
THE SCREWS
Panels C & D
The mounting
Rails should be
positioned at the
front of the rack
If fitting Plexi-Glass
Doors put this edge
at the FRONT of the
rack
Check all the
drilled edges are
on the same side
C
A

A
D
C
B Position top panel Binside
C & D in-line with the connectors
Using the heel of your hand tap
the sides into place
DO NOT TIGHTEN ANY
SCREWS
(Part of the Penn-Elcom Group)
Finally fit the
Four Stick-On feet.
You are now ready to
populate your rack
Once aligned start to
tighten the screws
These can be very tight,
so a quality crosshead
screwdriver is advised
They lock in place with a
double ‘click’
DO NOT USE POWER
TOOLS
These could snap the
head off the screw
Now check & align the sides
they should fit 2mm inside
all leading edges
If they are tight just tap
with the flat of your hand
DO NOT USE TOOLS
2012– Credenza Wooden Racks are the exclusive design copyright of Rackz Ltd – Bristol – BS15 8DT - UK