Philips HeartStart MRx User manual

DU-PH-0050-03 Rev D 3/27/12 GCX Corp. Page 1 of 3
Installation Guide
Philips Heartstart MRx and Heartstart XL+ Defibrillator –Flush Wall Mount Kit
The purpose of this guide is to:
1. Describe installation of the Mounting Assembly (page 2).
2. Describe mounting of defibrillator on the Mounting Assembly (page 2).
Parts Reference
The following parts and hardware are included with this installation kit (see photo for part; hardware not shown):
Tools Required
• 1/8'' hex wrench (provided)
Item #
Description
Qty
1
Wall Mount
1
2
Channel Cover (includes instructions)
1
3
1/8'' Hex Wrench
1
1

DU-PH-0050-03 Rev D 3/27/12 GCX Corp. Page 2 of 3
Installing Mounting Assembly in Channel
1. Insert channel slide (rear of Mounting Assembly) in Channel. Slide Mount to
desired position in channel and tighten two (2) set screws (right) with 1/8'' hex
wrench provided.
Mounting the Heartstart MRx
1. Pull Plunger and open the Bed Hook Latch (below left).
2. Hook the bed hook (rear of Heartstart MRx) over the Mounting Bar (below center).
3. Close the Bed Hook Latch over the bed hook, ensuring that the Plunger snaps snaps into clearance hole (below right).
Insert Slide
Set Screws (2)
Plunger/Latch Open
Latch Closed

DU-PH-0050-03 Rev D 3/27/12 GCX Corp. Page 3 of 3
Periodic Maintenance
Periodically inspect all fasteners associated with the mounting system. Tighten or adjust fasteners as necessary for
optimal operation and safety.
Cleaning the Mounting Assembly
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone or
trichloroethylene.
3. Do not use Steel wool or other abrasive material.
4. Damage caused by the use of unapproved substances or processes will not be warranted. We recommend testing of
any cleaning solution on a small area of the mounting assembly that is not visible to verify compatibility.
5. Never submerge or allow liquids to enter the mounting assembly. Wipe any cleaning agents off of the mounting
assembly immediately using a water-dampened cloth. Dry the mounting assembly thoroughly after cleaning.
CAUTION: GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling
infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize mounted devices or
accessory equipment, refer to the specific instructions delivered with those products.
BaseColumn#10-32 x 9/16''
FHMS (3)
Manual Tilt
Clamp
#10-32 x 5/8''
FHSCS (3)
#10 x 1-1/2''
FHSMS (3)
Pic 6Pic 5Pic 4#10 x 1-1/2
FHSMS (3)
#10-32 x 5/8''
FHSCS (3)
#10-32 x 9/16''
FHMS (3)
Pic 2Pic 3Pic 1Swivel HeadRoll Stand Post