Philips BT5580 User manual

www.philips.com/welcome
User manual
Always there to help you
Register your product and get support at
BT5580
BT5880
Question?
Contact
Philips

1EN
Contents
Contents
1 Important 2
2 Your Bluetooth speaker 3
Introduction 3
What's in the box 3
Overview of the speaker 4
3 Get started 5
Power supply 5
Turn on 5
4 Use Bluetooth devices 6
Connect a device 6
Play from Bluetooth device 7
Control your phone call 7
Disconnect the Bluetooth-enabled device 7
Enter Bluetooth pairing mode 7
Connect another Bluetooth-enabled
device 7
5 Other features 8
Listen to an external device 8
Charge your m obile devices 8
Adjust volume 8
6 Product information 9
Specications 9
7 Troubleshooting 10
General 10
About Bluetooth device 10
8 Notice 11
Compliance 11
Care of the environment 11
Trademark notice 12

2EN
1 Important
Warning
•Never remove the casing of this speaker.
•Never lubricate any part of this speaker.
•Never place this speaker on other electrical equipment.
•Keep this speaker away from direct sunlight, naked
amesorheat.
• Make sure that there is enough free space
around the speaker for ventilation.
• The battery shall not be exposed to
excessiveheatsuchassunshine,reorthe
like.
• Use only power supplies listed in the user
manual.
• The speaker shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on
thespeaker(e.g.liquidlledobjects,lighted
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
Note
•The type plate is located on the bottom of the product.

3EN
2 Your Bluetooth
speaker
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfromthe
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this speaker, you can
• enjoy audio from your Bluetooth-enabled
devices or other external audio devices;
and
• charge mobile devices through the micro
USB socket.
What's in the box
Check and identify the contents of your
package:
• Main unit
• AC/DC adaptor
• Short user manual
• Safetyandnoticeleaet
Short User Manual
www.philips.com/welcome
Always there to help you
Registeryour product and get support at
Question?
Contact
Philips

4EN
Overview of the speaker
a
• Turn the speaker on or off.
b PAIRING
• Enter Bluetooth pairing mode.
• Disconnect Bluetooth connection.
c DC IN
• Connect power.
d AUDIO IN
• Connect an external audio device.
e CHARGING
• Charge mobile devices in AC mode.
f Volume knob
• Adjust volume.
g
• Answer or reject an incoming call.
• End the current phone call.
• Transfer the call to your mobile device.
b
c
d
e
g
h
f
a
h NFC
• Connect a device with NFC feature
through Bluetooth.

5EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Power supply
Either AC power or battery can be used as
power supply of this product.
Option 1: Battery power
The speaker can operate on the built-in
rechargeable battery.
Note
•Rechargeable battery has a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
•Whenbatteryislow,theLEDindicatorashesred.
To recharge the built-in battery:
• Connect the speaker to AC power supply.
Option 2:AC power
Caution
•Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the speaker.
•Risk of electric shock! When you unplug the AC
adapter, always pull the plug from the socket. Never
pull the cord.
Connect the power adaptor to:
• the DC IN socket on the speaker.
• the wall outlet.
Turn on
Press .
» The speaker switches to Bluetooth
mode.
» TheLEDindicatorashesblue.
Note
•Ifbatteryislow,theLEDindicatorashesred.
Turn off
The speaker is turned off in the following
situations:
• Press again;
• The connection with Bluetooth device or
other device is invalid for 15 minutes; or
• Music playback is stopped for 15 minutes.
Working
mode
LED status
Off mode Flashing red while charging;Turned
off after fully charged.
Bluetooth
mode
Flashing blue while connecting or
waiting for pairing; Solid blue after
connected.
Audio-in
mode
No LED indication
DC IN

6EN
4 Use Bluetooth
devices
With this speaker, you can listen to audio from
Bluetooth-enabled devices and control the
incoming call through Bluetooth.
Connect a device
Note
•Make sure that your Bluetooth device is compatible
with this speaker.
•Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
•The speaker can memorize a maximum of 4 paired
devices.
•Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
•Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
•Keep away from any other electronic device that may
cause interference.
Option 1: Connect a device through
NFC
Near Field Communication (NFC) is a
technology that enables short-range wireless
communication between various NFC
compatible devices, such as mobile phones and
IC tags.
If your Bluetooth device supports NFC, you can
connect it with this speaker easily.
1 On your device, enable NFC and
Bluetooth functions (refer to the user
manual of the device).
2 Press on this speaker.
» TheLEDindicatorashesblue.
3 Tap the NFC tag on the top of the speaker
with the back of your Bluetooth device.
4 Follow the on-screen instructions to
complete the pairing and connection.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator turns solid blue.
Option 2: Connect a device manually
Note
•The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
1 Press .
» TheLEDindicatorashesblue.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
that can be paired (see the user manual of
the device).
3 When [Philips BT5580] or [Philips
BT5880] is displayed on your device,
select it to start pairing and connection.
If necessary, input “0000” as the pairing
password.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator turns solid blue.

7EN
Play from Bluetooth device
Note
•If there is an incoming call on the connected mobile
phone, music play pauses.
After successful Bluetooth connection, play
audio on the Bluetooth device.
» Audio streams from your Bluetooth
device to the speaker.
Control your phone call
After Bluetooth connection, you can control an
incoming call with this speaker.
Button Function
Press to answer an incoming call.
Press and hold to reject an incoming
call.
During a call, press to end the current
call.
During a call, press and hold to
transfer the call to your mobile device.
Disconnect the Bluetooth-
enabled device
• Press and hold PAIRING for two seconds;
• Disable Bluetooth on your device; or
• Move the device beyond the
communication range.
Enter Bluetooth pairing mode
Press and hold PAIRING for two seconds.
Connect another Bluetooth-
enabled device
Disable Bluetooth on the current device, and
then connect another device.

8EN
5 Other features
Listen to an external device
With this speaker, you can also listen to an
external audio device such as an MP3 player.
1 Connect an audio input cable (not
supplied) with a 3.5 mm connector on
both ends to
• the AUDIO IN socket on this speaker,
and
• the headphone socket on the external
device.
» The speaker switches to audio-in
mode automatically.
2 Play audio on the external device (refer to
its user manual).
Charge your mobile devices
You can charge your mobile devices through
the CHARGING socket.
Note
•The USB socket is for charging only.
• In AC power supply mode, connect to
your mobile device with a USB cable (not
supplied).
» Once the device is recognized, the
charging starts.
Adjust volume
Rotate the volume knob to increase or
decrease the volume.
CHARGING

9EN
6 Product
information
Note
•Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output
Power
10W RMS (BT5580);
12W RMS (BT5880)
Signal to Noise
Ratio
> 62 dBA
AUX Input 600 mV
Bluetooth
Bluetooth Version V4.0
SupportedProles HFP, A2DP, AVRCP
Range 10 m (Free space)
General information
Power Supply
- AC Power
(power
adapter)
Brand name: PHILIPS;
Model: OH-
1024A1202000U-VDE;
Input: 100-240 V~, 50/60 Hz,
650 mA
Output: 12 V 2 A
- Battery Li-ion battery (2200 mAh)
Charging
Voltage and
Current
5 V 1 A
Operation
Power
Consumption
AC 24 W
Dimensions -
Main Unit
(W x H x D) 210 x 201 x 55 mm
Weight - Main
Unit
1.4 kg

10 EN
7 Troubleshooting
Warning
•Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support).When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
General
No power
•Make sure that the AC power plug of the
unit is connected properly.
•Make sure that there is power at the AC
outlet.
•Recharge your speaker.
No sound or poor sound
•Adjust volume on the product.
•Adjust volume on the connected device.
No response from the speaker
•Restart the speaker.
Cannot charge mobile devices
•Make sure that AC power is connected
properly.
•Make sure that there is power at the AC
outlet.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Cannot connect with the device.
•The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
•This product is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
The paired device connects and disconnects
constantly.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
•For some devices, Bluetooth connection
may be deactivated automatically as a
power-saving feature.This does not indicate
any malfunction of this product.

11EN
8 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
Compliance
Hereby,WOOX Innovations declares that this
product is in compliance with the essential
requirements and other relevant provisions
ofDirective1999/5/EC.Youcanndthe
Declaration of Conformity on www.philips.com/
support.
Care of the environment
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and
do not dispose of your old products with your
1177
normal household waste. Correct disposal of
your old product helps to prevent potential
negative consequences for the environment and
human health.
Your product contains batteries covered by
the European Directive 2006/66/EC, which
cannot be disposed with normal household
waste.Please inform yourself about the local
rules on separate collection of batteries
because correct disposal helps to prevent
negative consequences for the environmental
and human health.
Caution
•Removal of the built-in battery invalidates the warranty
and may destroy the product.
Always bring your product to a professional to
remove the built-in battery.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.

12 EN
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by WOOX
Innovations is under license.
The N Mark is a trademark or registered
trademark of NFC Forum, Inc. in the United
States and in other countries.
This is CLASS II apparatus with double
insulation, and no protective earth provided.

13EN

Specifications are subject to change without notice.
2014 © WOOX Innovations Limited.All rights reserved.
Philips and the Philips’ Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used by WOOX
Innovations Limited under license from Koninklijke Philips N.V.
BT5580_BT5880_12_UM_V1.0