Playcore DERO Bike User manual

©2021
Bike Bike Rack Setbacks
STREET
STREET
WALL
WALL
90"
76"
36"
24"

©2021
Installation Surface MountBike Bike Rack
RECOMMENDED BASE MATERIAL
Solid concrete is the best base material for installation. To ensure the proper anchors
are shipped with your rack, ask your Dero representative which anchor is appropriate
for your application. Be sure nothing is underneath the base material that could be
damaged by drilling.
TOOLS NEEDED
Tape Measure
Marker or Pencil
Masonry Drill Bit 3/8”
Drill (Hammer drill recommended)
Hammer
Wrench 9/16”
Level
Drill 3/8” diameter holes 3” deep into surface. Make sure the
holes are at least 3” away from any cracks in the base material.
Thread nuts onto anchors, leaving approximately 1/4” of the
anchor protruding, and tap into surface. Tighten nuts down to
secure rack.
Place the rack in the desired location. Use a marker or pencil to
outline the holes of the flange onto the base material.
Use washers to level rack if necessary.
1
3
2
4
Ø 3/8”
9/16”
3”

©2021
Installation In-Ground Mount : New ConcreteBike Bike Rack
TOOLS NEEDED
Level
Cement mixing tub
Shovel
Pour concrete and allow to cure.
An easy way to brace the Bike Bike Rack while the grout sets
is to bolt two 1x4” boards together at one end and clamp them
onto the wheel of the rack like a clothes pin.
Place corrosion resistant sleeve (min. 4” inside diameter) in sand
pour bed in exact location where rack will be installed. Make
sure top of sleeve is at same level as desired finished concrete
surface. Fill sleeve with sand to keep it in place and prevent it
from filling with concrete.
After appropriate cure time, dig out sand from sleeves and insert
rack, making sure it is level and at the appropriate height. Pour in
Super Por-Rok or epoxy grout and allow to set.
1
3
2
Trowel
Corrosion-Resistant Sleeve (min. 4” diameter)
Materials to build brace (see “Install Tip” at bottom of page)
Sand pour bed
Sleeves
Final grade level
Poured concrete
(4-7” deep)
TIP

©2021
Installation In-Ground Mount : Existing ConcreteBike Bike Rack
TOOLS NEEDED
Level
Cement mixing tub
Shovel
Access to water hose
Fill holes with Super Por-Rok or epoxy grout.
An easy way to brace the rack while the grout sets is to bolt two
1x4” boards together at one end and clamp them onto the wheel
of the rack like a clothes pin.
Core holes no less than 4” diameter and no less than 11” deep
into sidewalk.
Place rack into holes, making sure the rack is level until the grout
has set.
1
3
2
Trowel
Hole coring machine with 4” bit
Materials to build brace (see “Install Tip” at bottom of page)
TIP
Ø 4” min.
11” min.

©2021
Installation Footing DiagramsBike Bike Rack
12”
48”
10”
18”
24”
IN-GROUND MOUNT SURFACE MOUNT
(or standard 4” sidewalk slab)