PLAYNETIC MusicBall User manual

MB90003_23062020
Loohorst 3 | 7207 BL Zutphen | The Netherlands
[email protected] | www.playnetic.nl | [phone]
MusicBall
User Manual

Loohorst 3 | 7207 BL Zutphen | The Netherlands
[email protected] | www.playnetic.nl | [phone]
Install the Product
Overview Product
Control the Volume
Change the Content
Maintenance
Check Interactive Elements
Play and Test
Install and Manage a Timelock
3
3
4
5
7
3
4
6
2

Install the Product
Install the product according to the Playnetic Installation Manual.
During the installation, make sure that the potential users can not
be exposed to hazards / dangerous situations. Check the stability
of the product.
Number of Users
Playnetic recommends you to use the product with a maximum of
two users.
3
Overview Product
The overview above shows where all important parts can be
found.
Check Interactive Elements
Use the product and generate energy. If applicable, check that the
interactive elements such as the music, lights, smell, electronic- and
mechanical parts are working properly.
Service hatch
Crank ball
Speaker

Control the Volume
1. Remove the bolts with the supplied hex key.
2. Remove the service hatch with the label.
3. Generate energy with the product.
4. Adjust the volume.
5. Close the service hatch.
Play and Test
1. Spin the handle to Generate energy with the product.
2. Test if the different fragments are played properly.
*Are the tests incorrect? Then change the content. Follow
the instructions in the Playnetic User Manual.
4
Read on
Volume

USB Stick Content Requirements
Get a USB stick (from inside the MusicBall).
Make sure that you meet the following requirements:
a. Only use MP3-files.
b. The name of the MP3 file needs to have at least 5 characters.
c. The name of the MP3 file can’t contain any strange characters.
d. A single MP3 file can not be bigger than 2 MB.
5
Change the Content
1. Use the supplied hex key and unscrew the service-hatch bolts.
2. Remove the service hatch.
3. Remove the USB stick from inside the MusicBall.
4. Insert the USB stick into a computer and place the new
content / music on the USB stick. See the instruction on the right.
5. Insert the USB stick with the new content back into the
MusicBall.
6. Generate energy with the MusicBall. You should now be able
to hear your new content. If not, read the requirements on the
right again.
7. Make sure that you put the dust cover back over the
USB port.
8. Close the service hatch.
D
E

6
Receive TimeLock
1. Receive a USB device. Playnetic has set the
correct start- and endtime for you.
Install and Manage a Timelock
1. Remove the bolts with the supplied hex key.
2. Remove the service hatch.
3. Important! The timelock must be installed at 12
o’clock local time. If the install is being done too late or
too early, the time lock will not work properly.
4. Put the USB stick into the computer.
5. Generate energy. Wait until the update is completed.
Remove the USB stick after completion.
6. Make sure that you put the dust cover back over the
USB port.
7. Closethe service hatch.
“In progress, please wait...”
“Downloading data
completed, remove USB
device”

Maintenance
The product must be maintained according to the Playnetic
Maintenance Advice.
7