
3
ENGLISH
Use
Start by removing the battery hatch (2) and remove the USB
receiver. Insert 1x AA battery into the mouse, mind the polarity.
Put the battery hatch back in place. Turn on the mouse with the
[On/off] switch (1).
Insert the USB receiver into a free USB slot on your computer. The
drivers will rst install and then detect the mouse.
You are now connected to the mouse.
You can change the sensitivity of the mouse by pressing and
holding the left button (3) and scroll wheel (5) for 3 seconds at the
same time.
The mouse enters sleep mode if it is not been used in 10 minutes.
Move the mouse to wake it up again.
Troubleshooting
If the mouse isn't detected, turn the switch (1) to "Off", wait a few
seconds, turn the switch to "On" and it should be detected.
Care and maintenance
Wipe the mouse with a damp cloth.
Never use cleaning agents or solvents.
Safety information
Depleted batteries should be removed and replaced by a similar
kind. Dispose batteries according to local regulations.