Plow & Hearth Peacock Spinner User manual

Approximate time to assemble: 20 minutes
© 2015 Made in China exclusively for Plow & Hearth, Madison, VA 22727 plowandhearth.com 877-553-0369
A 1PC B 1PC C 1PC
D 2PCS E 2PCS F 2PCS G 2PCS
H 1PC I 1PC J 1PC K 1PC
L 4PCS M 1PC
A
BC
D
D
E
E
F
F
G
G
H
I
J
K
L
L
LL
M
Item #: 54352
Product Name: Peacock Spinner

© 2015 Made in China exclusively for Plow & Hearth®, Madison, Va. 22727 plowandhearth.com 877-553-0369
Item #: 54352 Product Name: Peacock Spinner
Time to Assemble: Approximately 20 minutes
Outdoor Use Only
Assembly Instructions
Step 1. To assemble the Decorative Spinner Head, slide Spinner (B) onto one of the threaded ends of the T Bar
(A).The smooth side of the Spinner should be facing outward, with the ribbed side facing the T Bar.
Next, thread one of the Nuts (D) onto the T Bar and tighten with the Wrench (L) to secure the Spinner.
Slip one of the Spacers (E) onto the exposed thread of the T Bar so it covers the Nut (D), and add one Split Ring
Lock Washer (F) and one Cap Nut (G) to secure the Spacer, again tightening with the Wrench (M).
To add the other Spinner, repeat the above steps, sliding on remaining Spinner (C), smooth side facing outward,
threading on Nut (D), and add one Spacer (E), one Split Ring Lock Washer (F), and one Cap Nut (G). The ribs of
the Spinners should be facing each other once the Decorative Spinner Head is assembled.
Step 2. To assemble the Stake Pole, slide the Double Prong Stake (I) onto the Ground Stake (H), then thread the
Extension (J) onto the Ground Stake (H), and thread Spinner Mount (K) onto Extension (I). To ensure pole sections
remain securely connected, insert the 4 Screws (L) into the aligned holes at each section.
Step 3. Finally, place the assembled Decorative Spinner Head onto the Spinner Mount (K), and install the Spinner
in a choice location. To install, push the three stakes into the ground, softening with water if needed to make it
easier to drive the stakes in. Use care not to over saturate the ground.