18. Install Argon Tank to the
Argon Hose Assembly, tighten
using the Argon Handle and
press t Argon Cap
CL
10. Use screws W (4) to secure
the Exhaust Fans at the back
of the cabinet, ensuring air
ow is upwards
2. Align center of the Mounting
Template to center line and front
edge to edge of cabinet
11. Turn the Plum around and
remove Argon Door using the
L-shaped Key (tamperproof
T-10 Torx)
12. Using the Argon Handle
provided, remove the Argon
Tank and set aside for later
9. Place the Exhaust Fans, green
ring above and red ring below,
in the center of the cabinet vent
opening in the back
13. Screw in Argon Hose
Assembly and hand tighten
14. Plug Plum and fan power
cords into the switched to
“OFF”wall outlet
OFF
ON
15. Plug cord into Plum and set
Plum power switch to the“ON”
position. Place Plum in the cabinet
tight against Stop Washers and
secure with screws J (4)
16. Place free end of Argon Hose
Asembly into Argon Tank Cradle,
taking care to align the slots,
secure with Argon Tank Bracket
using screws D (2)
17. Add Inner Trim Panel secured
with screws J (12) *American-size
cabinets need the Spacer Blocks
secured with screws Q (6)
19. Clip in Trim Kit Door and
adjust door position as required
using hinge adjustment screws
20. Switch wall outlet to the “ON”
position to power up your Plum
CL
