ErgoCan EC1119 User manual

EC1119EC1818EC2626
SIGNBOARD INSTALLATION
Utility Knife Required
Short BracketRiserSign Board Frame
11 Fastners
11 Fastners
11 Fastners
Short BracketRiserSign Board Frame
Long BracketRiserSign Board Frame
PAGE 1

Install brackets on to riser
Use short brackets
Use short brackets
No brackets added
1. Slide the bracket over the riser holes
2. Snap brackets onto holes
3. Insert fasteners into holes
EC1119 - Long Side
STEP 1
EC1818
EC1119 - Short Side
EC2626
Use long brackets
8 Fastners
8 Fastners
8 Fastners 8 Fastners
GAP
IN BRACKET
NO GAP
IN BRACKET
PAGE 2

STEP 2
Insert assembled riser/bracket into bin
1. Measure panel length,
then mark a line with a pen
on the panel.
(See Panel Cut List above.)
2. Cut panel with utility
knife along the line
1. Slide cut panel into tracks
2. Slide riser/brackets into tracks
note: apply even pressure so
riser slides in straight/even
1. Remove Lid
2. Remove Panel
CUT PANEL EXAMPLE
EC1119 SHORT PANEL
20”
Marking
Line
EC1119
EC1119
EC1818
EC2626
SHORT PANEL
LONG PANEL
20”
19”
19”
22 ”
¼
PANEL CUT LIST
PAGE 3

STEP 3
STEP 5
STEP 4
Insert fasteners into holes
Insert the graphic display panel into
the signboard frame through open end
of frame.
Attach the signboard frame by inserting signboard frame
onto riser tabs shown by arrows through the slots on the
signboard frame. Push frame down into the narrow part of
the slot, thus locking it into place.
LANDSCAPE PORTRAIT
COMPLETED INSTALLATION
PORTRAIT LANDSCAPE
PAGE 4