Point Source Audio CM-PTT-M1 User manual

Note: Product pictured is for
illustrative purposes and may
not exactly represent the
product you have purchased.
REGISTER YOUR WARRANTY
point-sourceaudio.com/support
Model #
CM-PTT-M1
© 2024 Point Source Audio. All rights reserved.
The Point Source Audio logo is a registered trademark of Point Source Audio.
Failure to observe
proper use of this
product could
result in voiding
your warranty.
CM-PTT-M1 Push-to-Talk | USER GUIDE
The CM-PTT-M1 works with
the Point Source Audio CM-i3
or CM-i5 in-ear headset to
combine the connectivity
between an intercom pack
and a Motorola™ radio. No
more fumbling between two
discrete systems or removing
your headset to use a radio.

Model #
ADP-M1xM4
from M1 to M4
Motorola Adapters
Model#
ADP-M1xM7
from M1 to M7
Model#
ADP-M1xM9
from M1 to M9
Cable Lengths not to Scale
REGISTER YOUR WARRANTY: point-sourceaudio.com/support
The CM-i headset with the CM-PTT-M1 gives
you the freedom to seamlessly communicate
with your teams on both intercom and radio.
Get connected in three easy steps:
Step 1
Connect the first XLR cable of the CM-PTT-M1
to your CM-i headset.
Step 2
Connect the second XLR cable of the CM-PTT-
M1 directly to your intercom pack.
Step 3
Connect the 2-pin coiled cable to the Motorola
M1 radio. (See available dapters for M4, M7 and
M9 radios.)
Your comms system is active by default. To
engage the radio, simply press and hold the
push-to-talk button!
©2024 PointSource Audio
CM-PTT-M1 Push to Talk | USER GUIDE