Instr 9927953 Rev 01 2017-07 Page 5 of 8
9. Install the front auger carrier assembly rinto front
auger mount qand secure into position using
supplied hitch pin t.
10.Install the rear auger carrier assembly einto rear
auger mount wand secure into position using
supplied hitch pin t.
11. Place auger onto front and rear mount with the
powerhead of the auger towards the front of the
machine and ensure that the auger shaft is fully
seated into the front and rear V-groove supports.
NOTE
The Titan Ice Auger Carrier Kit comes assembled to
accept augers that operate in a clockwise (right
hand) rotation. If your auger operates in a
counterclockwise (left hand) rotation you will need to
replace the standard rear strap plate Hwith the
optional LH rear strap plate uthat was supplied with
your kit. See Step 11a-11c for installation of the
optional LH rear strap plate.
a. To install the LH rear auger strap plate, PN
5264841, remove the fasteners J/Kholding
the RH rear auger strap plate assembly in
place.
NOTE
You will need to remove the strap Land latch
mechanism Mfrom the standard rear auger strap
plate and install onto the LH rear auger plate strap.
