Page 7
Calibrating your AutoPod
Your elevation should not need calibration as this is done from the factory but if for any reason the power
is cut o when the unit is in the raised position or you are operating two elevation units together then you
may need to re-calibrate the unit(s)
To calibrate remove the 15M leg extension cable, Network cables (if being used) and plug the leg(s) into the
ACU using the 3M leg cable.
Using either the foot control pedal or hand control unit, press and hold down the “ DOWN “ button for 3-5
seconds until the leg moves down slightly. Then simply raise the leg up a few centimetres and calibration is
complete.
You may now plug in your 15M leg extension cable if needed.
Calibration
Hand controller height calibration
The hand control unit has a numerical display which measures in Centimetres and can be re-calibrated to
your needs, either to the height of the equipment on top or centimetres from the bottom of the Autopod
stroke.
If you want to change the display, move the AutoPod to the required position.
Simultaneously hold down the “up” and “down” arrows until 3 dashes appear on the display.
This will be followed by a number value being displayed. In order to change the numerical display you must
press the”up”or“down” keys to select the numerical value you want displayed at the current height.
After several seconds the numbers will ash and the new setting is stored.
NOTE : The system will not let you choose value that would lead to a negative number on the display when
the column is lowered.
Hand controller error codes
In the event of a system fault, your hand control unit may display and error code :
E01 : The Elevation unit position is unknown – Should this happen, re-calibrate the leg as explained in the
calibration section above
E02: Overload in upward direction has occurred - reduce the payload.
E03: Overload in downward direction has occurred - reduce the payload.
E16: illegal keys are pressed. – more than one signal/ command has been received by the system. Press one
button at a time
