OPERAI'NG
'NSIRUCT'ONS
FORI\/''NI-EIFITJTE V
micateswhenthee|ectricsupp|yisbeingfedtotheamp.
2. POWER
SWITCH:A three position suritch
- ON - OFF- ON. The reasonfor two
ONpositions
is to give you the optionto reverse
polarityto eliminate
6OHz
hum
and to avoid electrical shock when touching your instrument.
CHANNEI-
'
s. BASS
POTENTIOMETER:
flat settingat 12 o'clock. Turndial clockwise
to add up
to zodb of bass;turning counterclockwiserolls off up to 2odb of bass.
4. .THE
EDGE.
(GRAY
KNOB)
POTENTIOMETER
with Switch: when clicked on,
this is anothercircuit with completely different voicing - for contemporary
or
country. set "EDGE"
volume to your liking. cH I volume control is nonoperative
when "EDGE"
is being used. To return to cH l, click off switch or you may use
optional
footsl/itch. Youwill noticethe gain of the "EDGE"
is a little lessthan
regularCH
1.
5. TRTBLE
pOTENTIOMETER:
flat setting at 12 c'clock. Turn dial clockwise to add
up to 2gdb of Trebleor counterclockwise
to cut up to Zodbof Treble
6. CHANNEL
1 VOLUME
POTENTIOMETER:
AIIOWS
CONTTOI
OfVOIUME.
7. TONAL
COLOR
SWTTCH
- BOOSTOR A)T H,GHS center position is normal. Bv
flippingup to BOOST,
you've got an extra lOdb of highs;
or flip to CUT
(down)
and cut back 1Odb. Thisswitch works independently
of the Bass,Midrange
and
Treblecontrols.
8. INpUTS:
Hi Gain is used for most instruments. Lo Gain is usedfor instruments
with exceptionallyhot outputs such as organs,synthesizers
and other keyboards.
9. REVERB
POTENTIOMETER:
controls amountof reverb - HAMMOND
3 spring -
which can alsobe remotely
controlled
by a dual footswitch(optional).
10. MASTER
VOLUME
POTENTIOMETER:
will determinethe amount of output signal.
For quiet operation,set the MASTER
VOLUME
at 12 o'clock. Turn up channel
volume. For full power of output signal, run MASTER
VOLUME
wide open and turn
channelvolumesdown.
11. NORMAUCOMBINE
SWITCH:
in Normal
position,
each channel
is independent
of
the other. In coMBlNEposition, the two channelsare bridgedand operate
togther.
12. pREAMp
OUTJACK: this is solely a preampsignal for use with our SIDEKICK
cabinet,any other highquality amplifier
or mixer
or direct to recording
console.
13. REMOTE
FOOTSWITCH
JACK:
FOT
REVERB
ANDEDGE
14. REVERB
SWITCH:
to control reverb in Ch 1, Ch 2 or both
15. ON - OFFSWITCH
for Horn-
1HANNH-
2 - Sameas CH 1 (#3 TO #8) with the exceptionthat the "EDGE"
is replaced
h,,/
a MIDRANGE
control: flat setting at 12 o'clock. Turn dial clockwise to boost or to
left to cut-
LOWER
REARPANFI
1. EXTENSTON
SPEAKER
JACK:
output jack for use with our POLYTONE
monitor
cabinets Perfectlymatched for our amplifiers.
2. HEADPHONE
JACK: cuts out main speaker.
3. AC CORD
BRACKETS:
for wrap-around storageof power cord.
4. pOWER
CORD: for your safety, we use a three-wire line with a ground- lt is not
a good idea to removethe groundpin underany circumstances. lf it is necessary
to operatethe amp with the old 2 prong plugs, a suitable adapter shouldbe used-
Operatingamp with the proper grounding
receptacle reduceshazard
of shock-
5. FUSE: located in the cap of thi fuseholder,this strouldbe replacedwith one of
propervalue shouldit fail. In order to keep the guaranteein effect, you must
repiace this fuse with the correct rating, otherwisethe warranty will be voided.
Shouldyour amplifier repeatedly blow fuses, take it to your nearestqualified
service center for repair. FUSE
RATING:
2A (25OV)SLOW
BLOW.
2
