PondXpert Fountasia 3000 User manual

Fountasia 3000 & 4000
Assembly Instructions

Contents

Contents Explained
Four fountain head attachments
and fountain stem
Fountain pump unit and
three main base attachments
Fountain base connections to
enable the T’ piece to be used
Threaded nut to attach T’ piece
to fountain stem
Fountain pump T’piece
Stepped hosetail for
20-32mm pond hose

Not using the fountain
•The main base unit can be used without a
fountain attachment
•Choose one of the screw fit attachments as
shown on this slide
•This will be screwed into the top of the main
unit
•A hose can then be connected to the main
unit via the chosen fitment

Using the fountain
•Screw the attachment nut to the
main body of the unit (as shown
in picture A)
•Attach to the doubled threaded
end attachment (as shown in
picture B)
•This connected piece will then
be screwed onto the T’ piece
•This can then be screwed onto
the main unit and should look
like picture D
CD

Stepped hosetail
•The stepped hosetail is used
along side the T’ piece as shown
•The stepped hosetail is able to
take 20-32mm width pond
hosetail
•The feed to this stepped hosetail
is controlled by the turn valve as
highligted

Fountain
Construction
•Firstly screw the threaded nut (as
shown in pictures A/B) into the
T’piece
•Next screw the fountain stem onto
the unit (as shown in picture C)
this can be extended to double its
original length if required
•Pick from one of the four enclosed
fountain attachments; these are
simply pushed on to the fountain
stem (as shown in picture D)