PoolGobbler Pro –User Guide
Switch on the pump and continue with 3 –OPTIMIZING YOUR
POOLGOBBLER PRO
2B. CONNECTING TO A SMOOTH PIPE.
Make sure that the pump still is switched off. Slide flexible sleeve A2
back onto the Universal Connector (picture).
If the inlet is a smooth pipe, we recommend to sand the inside to
ensure a better grip.
Insert the toothed end with the sleeve into the opening of the inlet
until the red rim touches the pool side. Fasten it by turning the
white wheel while holding the far end of the connector.
Slide the PoolGobbler Pro with its elbow B over the end of the
Universal Connector (you may have to push quite firmly) and secure
with clip F.
NOTE: It might occur that the connector doesn’t go in completely.
This can be solved by sliding a flange over the orange sleeve
(available at any DIY-plumbing dept, external diameter 70mm,
internal diameter 40mm, 6 mm thick).
3. OPTIMIZING YOUR POOLGOBBLER PRO.
Now your PoolGobbler Pro can be adjusted for optimal
performance. Please be aware that it might take several tries to
have it work at its best. Make sure that the pump is switched on.
a) POSITIONING YOUR POOLGOBBLER PRO.
Make sure that the floating head d is in a horizontal position on the
water surface.
PoolGobbler Pro will automatically position itself alongside the wall,
so it will not be in the way. If it does not position itself completely
alongside, you can achieve this by slightly turning the end of the
hose at the elbow (b) side.
b) POSITIONING OF THE NOZZLE OF THE FLOATING HEAD.
The position of the nozzle of the floating head greatly determines
the efficacy of the PoolGobbler. It should be ¾under / ¼ above the
water level. If this is not the case its level can be adjusted by slightly
turning elbow bat the side of the connector a.
c) ADJUSTING THE PRESSURE.
The pressure of the water streaming into the pool is important: if
the water flows too slowly, the captured debris might flow back into
the pool, if the water flows too fast, the debris might bounce back
into the pool.
If the water flows too slowly, its speed can be increased by partly
closing the other inlet jets. You can do this by turning the directional
ball in these jets such that the opening of the directional ball is
partly blocked by the cover.
If the water flows too fast you can reduce the speed by turning the
pressure adjustment ring on elbow bsuch that the opening pointing
downwards is open (the opening on top should always be closed!).
4. MAINTENANCE OF YOUR POOLGOBBLER PRO
Your PoolGobbler Pro requires very little maintenance. Its
installation is once off, which means that it does not need to be
removed during the season. If you cover your pool during the night
or a longer absence the cover can be put over your PoolGobbler.
a) EMPTYING THE FILTER BAG.
The filter bag should be emptied before it is half full.
Switch off the pump and take holder ewith the filter bag from the
PoolGobbler.
Empty the filter bag, when it is damaged it should be replaced, if it is
just dirty it can be washed.
Put the filter bag back onto the holder and slide it back into the
floating head.
Switch on the pump.
b) HIBERNATING YOUR POOLGOBBLER PRO.
When you prepare your pool for the winter season do as follows:
If the PoolGobbler Pro is connected to a cover remove the
cover from the inlet jet together with the PoolGobbler still attached
to it. Remove the filter bag, clean the PoolGobbler with lukewarm
soapy water and store it .
If the PoolGobbler Pro is connected to a smooth pipe or
connected directly into the opening of the inlet jet, you can remove
it by turning the big white wheel.
Remove the filter bag, clean the PoolGobbler with lukewarm soapy
water and store it .
www.poolgoods.eu / info@poolgoods.eu
