pottery barn kids BLYTHE WARDROBE RACK User manual

Date: 2016-May-21
Rev: Page 1 of 4
pottery barn kids
BLYTHE WARDROBE RACK
www.potterybarnk i ds .com

Date: 2016-May-21
Rev: Page 2 of 4
IMPORTANT SAFETY INSTRUCTIONS:
•Please read all instructions carefully before assembling.
•For your safety, assembly by two or more adults is strongly recommended.
•Keep these instructions for future use.
•Use only vendor-supplied hardware to assemble this item. Using unauthorized hardware could
jeopardize the structural integrity of the wardrobe rack.
PRE-ASSEMBLY:
•Remove all parts and hardware from the box. Place all items on a carpeted or scratch-free work
surface, as this will avoid damaging parts during assembly. The shipping box provides an ideal work
surface.
•To avoid accidentally discarding small parts or hardware, do not dispose of any packaging or contents
of the shipping carton until assembly is complete.
•Use the parts and hardware lists below to identify and separate each of the pieces included.
•The illustrations provided allow for easier assembly when used in conjunction with the assembly
instructions.
•The use of power tools to aid in assembly is not recommended. Power tools can damage the hardware
and split the wood.
•Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may
cause the bolts to misalign during assembly.
PARTS INCLUDED:
(A) Hanging bar (x1)
(B) Post (x2)
(C) Base (x1)
HARDWARE INCLUDED:
(D) Allen Key with ball tip
– 1x
(E) Allen bolt 1/4”x45mm
– 4x
(F) Spring Washer 1/4” – 4x
(G) Flat Washer 1/4” –4x
(H) Magnetic Decor
Cover – 2x

Date: 2016-May-21
Rev: Page 3 of 4
ASSEMBLY INSTRUCTION STEPS:
1. Attach (B) to (C) by aligning wooden dowels on (B) with pre-drilled holes on (C), as seen in the
illustration below.
Noted:
Make sure the label at the bottom of (B) is facing inwards.
Do not fully tighten the bolts to make the next steps easier.
2. Attach (A) to (B) by spreading (B) and aligning tenons on (A) with pre-drilled holes on (B).
3. Secure (A) as seen in the illustration below.
4. Check the alignments and fully tighten all Bolts at this time. Do not over tighten.
E 2x
F 2x
G 2x
E 2x
F
2x
G 2x

Date: 2016-May-21
Rev: Page 4 of 4
5. Turn the unit upright. Attach (H) to (B), as shown below.
6. Assembly is now completed.
CARE INSTRUCTIONS:
•Dust often using a clean, soft, dry, and lint-free cloth.
•Blot spills immediately and wipe with a clean, damp cloth.
•We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our
lacquered finish.
•Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
Thank you for your purchase
Stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181