PowerGistics 1T1216TRM0 User manual

100 Continental Drive, Columbus, Wisconsin 53925 USA
201-389-9940 | www.PowerGistics.com
STAND TOWER RETRO MOUNT
INSTALLATION GUIDE
Model # 1T1216TRM0 for Tower12 or Tower16 pre-2017
Model # 1T1820TRM0 for Tower18 or Tower20 pre-2017

201-389-9940 | www.PowerGistics.com 3
Please read the warnings below for important safety information regarding your product.
Failure to read these warnings or to follow the instructions below could result in personal
injury or damage to your product that could void its warranty.
• DO NOT PLUG POWERGISTICS TOWERS INTO OTHER TOWERS.
MUST BE PLUGGED DIRECTLY INTO THE WALL OUTLET.
• WALL MOUNTED TOWER MUST HAVE THE BASE RESTING
ON THE FLOOR.
• SHELF WEIGHT RATING: 5 LBS PER SHELF.
In its unassembled state, small
parts present a hazard.
Ensure that any cables
extending across the oor
to your product are properly
bundled and marked to avoid
tripping or falling which may
lead to personal injury.
This product is intended for
indoor use only. To reduce the
risk of re or electric shock,
do not expose this product to
rain or moisture. The internal
components are not sealed
from the environment.
Read your power strip’s
electrical specications.
Only plug in to devices that
are approved for use with
this power strip. Connect the
supplied power strip directly
to a wall outlet. The socket-
outlet shall be installed near
the equipment and shall be
easily accessible. Do not
connect to another power
strip or use an extension cord.
Unplug when not in use.
Must be assembled by an
adult.
Do not install or use the
electrical components
of this unit during a
lightning storm.
Do not climb on, hang
from or suspend objects
from any components
of your product unless
otherwise specied.
Read the electrical
specications of any
electronic equipment
you are using with your
PowerGistics products.
Failure to read these
specications and
follow their instructions
could result in damage
to your equipment or
personal injury.
WARNINGS WARNINGS

4
Adapter Kit includes:
- stand adapter bars
- hex wrench
- nuts
- carriage bolts
- socket head screws
Two separate
spine adapters
t between
one of the
contemporary
Just-A-Stands
or Stand on any
older Tower.

201-389-9940 | www.PowerGistics.com 5
1. Insert hex-head
bolts to the Tower
spine.
NOTE:
Leave screws
sticking out for the
adapters to go on.

6
2. Position the stand adapters to the socket head screws.

201-389-9940 | www.PowerGistics.com 7
3. Tighten the socket head screws.
Use either method to tighten
socket head screws.

8
4. Place the Tower on the adapters. Line up the holes in the
Tower spine with the hole slot on the adapters.
5. Insert the carriage bolts and tighten with the nuts.

201-389-9940 | www.PowerGistics.com 9

10

100 Continental Drive, Columbus, Wisconsin 53925 USA
201-389-9940 | www.PowerGistics.com
PWRG 1157 Tower Stand Adapter INSTALL GUIDE 2023
Check out our installation videos at
Vea nuestros videos de instalación en
Se vores installationsvideoer på
Découvrez nos vidéos d’installation sur
https://powergistics.com/tower-series-install-videos/