PowerStation PSX User manual

© Copyright 2008, PowerStation, LLC
All rights reserved
OWNER’S MANUAL
MANUAL DEL PROPIETARIO
Model: PSX
Copyright © 2008 Powerstation, LLC
All Rights Reserved
Modelo: PSX
Derechos de autor © 2008 Powerstation, LLC
Todos los derechos reservados
Jumpstarts dead batteries in seconds
Arranca baterías agotadas en segundos
CHARGE PRIOR TO INITIAL USE. COMPLETELY RECHARGE AT LEAST ONCE EVERY MONTH.
CARGUE ANTES DEL USO INICIAL. CÁRGUELO COMPLETAMENTE AL MENOS UNA VEZ AL MES.

CONTENTS
Warning Information 1–4
Introduction 5
Features 5
Getting to know your PSX 6-7
Operation 8-9
Charging before initial use 8
Standard recharging of the PSX 8
12V DC recharging of the PSX 9
Use of the PSX 9-13
Jumpstarting precautions 9-10
Using the jumpstart 11
Using the integrated work light 12
Using the compressor 12
Inating a tire or object 12
Inating other objects 12-13
Operating DC appliances 13
Replacement Parts 13
Notes 29
NOTICE:
If you experience any problems with the PSX, please DO NOT return
the unit to the place of purchase. Please call PowerStation’s Technical
support staff toll free at 1-800-837-5994.

PSX Owners Manual Page 1
082508
WARNING INFORMATION
This manual contains information regarding safety, operation, maintenance
and storage of this product.
Please carefully read and understand this manual before using this product
to avoid possible injury or property damage.
Keep this manual for future reference.
RISK OF FIRE, EXPLOSION OR BURNS.
This unit has no user-serviceable parts within the housing.
Have a qualied technician complete any service work.
Never allow the jumpstart’s red and black cable clamps to touch
each other or a common metal conductor. Such contact could
cause damage to the unit and/or create a sparking/explosion
hazard.
Connect red clamp to the positive (+) battery terminal. The black
clamp should be attached to the engine block of stalled vehicle.
Do not connect black clamp to the negative (-) battery terminal;
doing so could cause damage to the unit and/or create a
sparking/explosion hazard.
Do not try to jumpstart a battery for more than six seconds.
Before repeating the jump starting cycle, allow the unit to cool
for three minutes.
The jumpstarting cable connection has enough energy to cause
a spark, create an explosion hazard or cause burns if a metal
object contacts both terminals. Do not turn on the jumpstarting
function without having cables properly attached to the vehicle’s
battery.
Do not leave the compressor unattended while operating.
The compressor must be allowed to cool for ten minutes
following each ten minutes of continuous use.
Do not expose the PSX to temperatures greater than 104°F
(40°C). The operational temperature range for the sealed lead
acid battery is 5°F to 122°F (-15°C to 50°C) when discharged
(or in use) and 32°F to 104°F (0°C to 40°C) when charged and
5°F to 104°F (-15°C to 40°C) during storage.
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING

PSX Owners Manual Page 2
082508
WARNING INFORMATION continued
RISK OF FIRE, EXPLOSION OR BURNS (continued).
Do not use this unit where there are combustible fumes or
gases. Do not use in an enclosure containing automotive-style
lead acid batteries.
RISK OF PERSONAL INJURY, DEATH OR DAMAGE TO
EQUIPMENT.
ALWAYS wear approved eye protection when using this
equipment.
Make sure the jumpstart is safely secured when transporting.
If the unit is not properly secured during an accident the unit
could hit the driver or passengers.
Do not exceed recommended air pressure of object being
inated.
SHOCK HAZARD.
Keep away from children. Do not insert foreign objects into the
DC power socket, ventilation slots, or any opening in the unit.
Do not expose the unit to water, snow, spray or excessive
moisture.
CAUTION.
Contains a sealed lead acid battery. Keep dry. Do not drop.
See owners guide for proper charging procedures. Dispose of
battery according to local regulations.
Never attempt to jumpstart a frozen battery. Gradually
warm the frozen battery to a minimum of 40°F (4°C)
before jumpstarting.
To avoid possible damage and/or a shortening of the unit’s
working life, protect the unit from direct sunlight, direct heat,
and/or moisture.
The jumpstart function is designed to be used only on vehicles
or boats with 12V electrical systems.
This unit is not designed to be used in the place of a vehicle
battery.
This unit is not designed to be used as a battery charger.
WARNING
WARNING
WARNING
WARNING
WARNING
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION

PSX Owners Manual Page 3
082508
WARNING INFORMATION continued
INSTRUCTIONS FOR JUMPSTARTING AN ENGINE:
Batteries contain acid and produce explosive gases
Note: Consult the owner’s manual for complete instructions. SHIELD THE EYES AND
FACE FORM THE BATTERIES AT ALL TIMES. Be sure the vent caps are tight and level.
Place a damp cloth, if available, over any vent caps on both batteries. Be sure the vehicles
do not touch and that both electrical systems are off and at the same voltage. These
instructions are for negative ground systems only.
1. Connect the positive (+) cable to the positive (+) terminal of the discharged
battery that is wired to the starter or solenoid.
2. Connect the other end of the positive cable to the positive terminal of the
booster battery.
3. Connect the black negative (-) cable to the other terminal (negative) of the
booster battery.
4. MAKE THE FINAL CONNECTION ON THE ENGINE BLOCK OF THE
STALLED VEHICLE (NOT TO THE NEGATIVE POST) AWAY FROM THE
BATTERY. STAND BACK.
5. Start the vehicle and remove the cables in the reverse order of connection
(the engine block (black) connection is the rst to disconnect).
BATTERY BOOSTER CABLE INSTRUCTIONS FOR JUMP STARTING
AN ENGINE:
Batteries contain and produce explosive gases.
These instructions are designed to minimize the explosion hazard. Keep sparks,
ames, and cigarettes away from the batteries at all times. Wear safety glasses,
and protect the eyes at all times.
Do not lean over the batteries during this operation.
Both the battery to be jumped and the booster source must be the same voltage
(6 or 12 V, etc.).
Power sources other than batteries should not exceed 16 V DC for use with the
12 V systems, and 8 V DC for use with a 6 V DC system.
continued
WARNING
WARNING

PSX Owners Manual Page 4
082508
WARNING INFORMATION continued
BATTERY BOOSTER CABLE INSTRUCTIONS FOR JUMP STARTING
AN ENGINE (continued):
Position the vehicle with the booster battery, or other power source, adjacent
to the vehicle with the discharged battery so that the booster cables can be
connected easily between both vehicles. Make certain that the vehicles do not
touch each other.
1. Turn off all electrical loads on all vehicles and set the parking brake. Place
the automatic transmission in “PARK” (manual transmission in “NEUTRAL”).
2. Determine whether the discharged battery has the negative (-) or the positive
(+) terminal connected to the ground. The ground lead is connected to the
engine block, the vehicle frame, or some other good metallic ground. The
battery terminal is connected to the starter is the one that is not grounded.
All vehicles manufactured in the USA after 1955 have the negative battery
terminal grounded. All European and Asian passenger vehicles manufactured
after 1971 have the negative battery terminal grounded.
3. On a negative ground system, connect the positive (+) cable to the positive
(+) terminal of the discharged battery wired to the starter solenoid. Do not
allow the positive cable clamps to touch any metal other than the battery
positive (+) terminals.
4. Be sure that the vent caps are tight and level on both batteries. Place a
damp cloth over any vent caps on each battery making certain it is clear of
fan blades, belts, and other moving parts.

PSX Owners Manual Page 5
082508
INTRODUCTION
Thank you for purchasing the PowerStation PSX. The PSX is a user-friendly &
versatile product designed to instantly jumpstart vehicles, provide portable
ination and 12V DC power. The PSX also brings light to any situation with an
integrated work light.
The PSX is an ideal companion to accompany all your jumpstarting, ination and
portable power needs.
FEATURES
• HighcurrentEHPbatteryprovides1,000Ampspeakpower,400Amps
starting power.
• Startscars,trucks,recreationalvehicles,andboatswithouttheneed
of a host vehicle or an AC power source.
• 12VDCpoweroutletprovidespowerforappliancesdesignedtopluginto
a vehicle or boat 12V power socket.
• Solid-state,integratedchargerallowsforre-chargingofthePSXbattery
from any 120V AC power source.
• Sealed,maintenance-freeheavydutybatteryissafetouse,transport,
and store.
• 37inch(94cm)heavy-dutyindustrialweldingcablesand400ampclamps
for maximum starting power.
• BatteryvoltmeterforquickassessmentofPSXinternalbatterystateofcharge.
• High-impactmoldedcaseprovidesdurabilityandconvenienttransport.
• LEDworklightforroadsiderepairsoremergencysituations.
• Highpressureaircompressorandadaptorscanaddressawiderangeof
ination needs.
• PressuregaugedisplaysairpressureinPSI.
• “CablesReversed”indicatorlightsindicatereversepolaritywarning.
• Includes12VDCpowercableand120VACchargercable.

PSX Owners Manual Page 6
082508
FIRST AID:
If battery acid comes in contact with skin, immediately flush with clean water, then
wash thoroughly with soap and water. If irritation or localized pain occurs, seek
immediate medical attention. For eyes, flush immediately with clean water for 15
minutes minimum. Seek medical attention IMMEDIATELY!
BATTERY DISPOSAL:
This unit contains a sealed, non-spillable lead-acid battery, which must be recycled or
disposed of properly. Contact your local waste management authority, toll free hotline
800-253-2687 or visit the website, www.earth911.org for disposal locations in your
local area. Under normal conditions and when used as instructed, your
PowerStation® battery should provide years of dependable service.
EWARNING E
B.
A.
B.
110V AC CHARGER
Figure 1
A. 12V DC outlet
B. Air inlet adaptors,
12V DC power cable,
and 120V AC charger
cable storage
C. Air inlet adaptors (3)
D. 12V DC power cable
E. 120V AC charger outlet
and charger cable
F. Air compressor and hose
storage
C.
D.
E.
GETTING TO KNOW YOUR PSX
E.
F.

PSX Owners Manual Page 7
082508
GETTING TO KNOW YOUR PSX continued
Figure 2
G. Battery test button
H. Voltmeter
I. Work light
J. Compressor gauge
K. Compressor ON/OFF button
L. Work light ON/OFF button
M. Indicator lights: cable power on / charging / full charge / cables reversed
N. Positive clamp
O. Negative clamp
P. Jumper cable ON/OFF switch
Q. Cables reversed LED indicator light
CHARGINGCABLE POWER FULL CHARGE
LIGHT
ON/OFF
CABLES REVERSED
BATTERY
TEST
COMPRESSOR
ON/OFF
PSXPS
CABLES REVERSED
OFF
ON
B. B.
B. B.
B.
G.
N. O.
P.
K.
H. J.
I.
L.
CHARGINGCABLE POWER ON
ON
FULL CHARGE CABLES REVERSED
M.
Q.

PSX Owners Manual Page 8
082508
OPERATION
Read all operating instructions before using your PSX.
This section will guide you through:
• Charging the PSX before initial use
• Standard recharging of the PSX
• Jumpstarting a vehicle
• Using the integrated work light
• Using the compressor
• Operating 12V DC outlet
Charging the PSX before initial use
We recommend charging the PSX on a regular basis. The initial charge could
take up to 72 hours.
Note: If the battery is fully discharged, up to 72 hours may be needed to completely
recharge. If you store your PSX for extended periods of time without use, completely
recharge at least once every month. The PSX is equipped with a sensor that prevents
overcharging.
Do not use the PSX as a power source while recharging.
Use the following step-by step guide to recharging your unit.
Standard Recharging of the PSX
We recommend charging the PSX on a regular basis. Even when not in regular
use, the PSX should be charged at least once per month to maintain optimum
performance.
Charge your PSX after each use.
To recharge the PowerStation internal battery using AC power:
1. Ensure that all elements of the unit are off and that nothing is
connected to the 12V DC outlet.
2. Plug the AC charger cable into the AC charger access point on the unit.
At this time the red “Battery Charging” indicator will illuminate.
3. Plug the AC charger cable into a standard wall AC outlet.
4. Allow unit to charge until the red “Battery Charging” indicator turns off
and the green “Full Charge” indicator is illuminated.
5. The charge level can be checked by rst disconnecting the AC charger
cable from the wall outlet and pressing the battery test button.
CAUTION
CAUTION