PowerTraveller startmonkey400 User manual

STARTMONKEY400
QUICK START GUIDE
HIGH-POWERED
RUGGED
EMERGENCY
JUMP STARTER
Locate the battery terminals. Check the battery
is 12V and maximum 1200 Cold Cranking Amps
Leave the startmonkey400 attached to the
vehicle battery for up to 60 seconds and then
turn on vehicle ignition as normal
DO NOT remove the startmonkey400 if the
green LED array is illuminated. The unit must
be turned off rst
Connect the black crocodile clip to the –
terminal and the red crocodile clip to the +
terminal. The startmonkey400 unit should
switch on automatically
If vehicle does not start rst time, remove
clips and then repeat steps 2-4. In very cold
temperatures this process may have to be
repeated several times
If the vehicle battery is below 6V the
startmonkey400 will need to be switched on
manually by pressing the ON/OFF button twice
in quick succession
Once the vehicle has started the startmonkey400
will turn off automatically and can be removed.
The startmonkey400 can also be switched off
manually by holding down the ON/OFF button
HOW TO JUMP START YOUR VEHICLE
21000mAh
500mAh
9000mAh
2500mAh
3500mAh
2200mAh
150mAh
750mAh
10500mAh
6000mAh
5600mAh
startmonkey400 unit
AFlexible, insulated crocodile clips B12V in-car charger C16V Universal AC Mains Charger D
A
B
D
C
To illuminate the screen, press the ON/OFF
button for 1 second
The startmonkey400 will automatically detect
the voltage of the battery when attached. If 6V
to 14V are detected the unit will switch on
12V
12V
+
60 Seconds
12V
+
12V
12V
+
x2
12V
+
12.0 v
Startmonkey
12V
+

Designed and developed in the UK
Engineered and made in China
Do not use with any other batteries apart from 12V vehicle batteries
Never use the manual over-ride feature to activate the
startmonkey400 on batteries which are not rated at 12V
If your vehicle will not start after it has been attached for up to 60
seconds and steps 2-4 have been repeated up to 7 times, leave
the startmonkey400 attached and retry after 10 minutes. If your
vehicle still will not start, please refer to your vehicle dealer
Do not remove the startmonkey400 if the green LED array is
illuminated. The unit must be turned off rst – to do this, hold
the ON/OFF button for 3 seconds
Never let the crocodile clips come into contact with each other
unless the startmonkey400 has been turned off
If using the startmonkey400 to jump-start a marine outboard engine
please ensure the startmonkey400 has been manually turned off
before removing
If you require further information or assistance, please contact
technical support on [phone]
To check the capacity of your startmonkey400,
press the ON/OFF button for 1 second
To charge the startmonkey400 using the 16V
Universal AC Mains Charger, insert the output
cable into the DC IN socket and connect to
the mains
You can recharge the startmonkey400 using
Powertraveller’s powergorilla (not included).
Connect the L52D tip to the connection cable
(both supplied with powergorilla) and select the
16V setting on the powergorilla. Plug into the
DC IN on the startmonkey400
The array of green LED lights will scroll up
and increase as the startmonkey400 is being
charged. Once all the LEDs remain solid green,
the unit is fully charged
HOW TO RECHARGE THE STARTMONKEY400
Bedienungsanleitung bitte von unserer
webseite runterladen
Allez sur notre site internet an de consulter
le mode d’emploi
Visitate il nostro website per scaricare le
istruzioni
Visita nuestra web para descargar el
manuel de usuario
Bezoek onze website om deze
gebruikershandleiding te downloaden
Other Powertraveller products can be purchased from
www.powertraveller.com
Customer support, email us at [e-mail] powertraveller.com/startmonkey400
POWERTRAVELLER LIMITED
Ceratech House, Omega Park,
Wilsom Road, Alton, Hampshire
GU34 2QE, UK
t [phone]
[e-mail]
The 4 blocks of LEDs will indicate the amount
of capacity left. Each block represents 25% of
the battery’s capacity (Hint: If less than 50% we
recommend you charge the unit)
To charge the startmonkey400 using the 12V
in-car charger, insert the output cable into the
DC IN socket and insert the 12V DC plug into
the socket in your vehicle. A full charged will
take approximately 4 hours from 50%
YOU CAN
CHARGE:
+MANY MORE
12V BATTERIES
STARTMONKEY400 IMPORTANT INFORMATION
SPECIFICATIONS:
• 7AH x 3 Lithium Polymer rechargeable battery
• Battery capacity: 21,000mAh
• Suitable for 12V batteries on vehicles with up to
1200 CCA
• Maximum jump-start current: 400A, 4,800 Watts
• Auto-on from 6V to 12V
• Working temperature: -27° to 50°C
• Weight: 1.1Kg
• Dimensions: 210 x 65 x 64 mm
All brands and trademarks belong to their respective owners.