PR Housewares Concept Housewares WR-40701 User manual

Metal Wine Bottle / Glass Wall Rack
Model WR-40701 & WR-40702
WR-40701 holds 8 Bottles and 16 - 24 Glasses
WR-40702 holds 4 Bottles and 8 - 16 Glasses
Concept Housewares, A Division of PR Housewares, LLC
www.prhousewares.com Email: [e-mail]
Photo B - WR-40702 Fully Assembled
Photo A - WR-40701 Fully Assembled
Photo C - Mounting Brackets
Photo D - Package of Screws.
Quantity may vary based on
product ordered.
Assembly:
To assemble, you will need the following:
- Level, pencil and tape measure
- Phillips head screw driver
- Hammer
- Electric drill and 5/16 drill bit
Lay out all the parts accordingly:
- Main unit (See Photo – A & B)
- Mounting brackets (See Photo – C)
- Package of wall screws and plastic anchors and plastic key
(See Photo – D)
Please consult with your local hardware store if you have
any questions or concerns about the construction of your
walls or ceilings. ey can assist you in selecting the proper
hardware and procedures. e generic hardware provided
will work for most drywall applications. NOTE: these units
are handmade, slight variations can exist, always measure
twice before drilling.
Mounting Directions:
1. Measure carefully where you want to mount the wine rack on
the wall. Assemble the side braces to the main unit and use a
pencil to mark where the screws attach to the wall.
2. Remove the unit and drill holes using a 5/16” drill bit. If
possible mount to wall studs. Supplied anchors have a pull
rating of 20 lbs. or more each and a shear rating of 50 lbs. each.
3. Insert the anchors into the drilled holes. ey may need to be
tapped in gently with a hammer. Use the supplied key to expand
the anchor behind drywall. (See Photos E to I on next page for
proper and improper anchor install).
4. Screw top screws into the le and right brackets into the
prepared holes. Do not tighten all the way yet.
5. Mount the main unit onto the braces, making sure that the
wine glasses will slide into the rack from the front ( See photo –
A & B ). Screw bottom screws of the le and right brackets into
the prepared holes, tighten all screws at this point.

Concept Housewares, A Division of PR Housewares, LLC
www.prhousewares.com Email: [e-mail]
Metal Wine Bottle / Glass Wall Rack
Model WR-40701 & WR-40702
Page 2
Photo E - Drill 5/16” diameter
(8mm) hole. Fold anchor in middle.
Photo F - Insert anchor in hole
and tap ush with wall.
Photo G - Insert key to pop anchor
open & lock behind hollow wall
(not necessary for thick or solid
walls). Do not force of hammer key.
Photo H - Place item over anchor. Insert screw and
tighten untill screw is ush with xture. Then, stop.
The anchors also wedge securely in thick or solid
walls, or in wood studs behind drywall.
Photo I - correct (top) and
incorrect (bottom).
Questions - Comments
Damaged ‐ Defective ‐ Missing Parts
Contact us rst, we will respond within 24 hours or less. Please provide our part number, your
order number, place of purchase, address and any other info so we may address your concerns
promptly.
[e-mail] or www.prhousewares.com
Thank you!
Returns are only accepted when returned in new condition and only with an RMA from the
seller.
Returns to: 501 I South Reino Rd. Ste 152. Newbury Park, CA 91320