Prime Water PRIME-501S User manual

16 17
Faucet Installation Guide Faucet Installation Guide
Cable Connector
Tubing - Orange
(Acidic Water Outlet)
Tubing - Blue
(Alkaline Water Outlet)
Tubing - White
(Tap Water) Dust Pre Filter
5/16”-1/4” Union Fitting
1/4”-1/4” Union Fitting
Fixing Nut
Cold Tap Water pipe
Adapter Valve
Alkaline Water
Outlet Adapter
Under counter
Installation Plug
33mm
Use appropriate tools to make 33mm diameter hole
in the location where you will set up the faucet.
Make sure the faucet location will allow both spouts to
reach the sink.
Insert the faucet in the hole and then screw
it with a nut to make it be fixed.
After the faucet is fixed, connect it to fitting hose
(for Alkaline-Blue). Check the hose whether it is inserted
properly or not. Also, connect it hose(for Acidic-Orange)
connect the faucet to the body.
1
2
3
Place the Ionizer in an appropriate place under your sink
Connect the Acidic Water Hose(Orange color) to the 1/4”-1/4” Union fitting on the Acidic Hose extending
from the faucet to Acidic Water Outlet on the Ionizer. Pull firmly to check to connection -
you should not be able to pull the hose out.
Connect the Alkaline Water Hose(Blue color) attached to the threaded stem of the faucet to the
Alkaline Water Outlet on the ionizer. Pull firmly to check to connection - you should not be
able to pull the hose out.
Install the dust pre-filter in the middle of a length of 1/4 inch hose with the arrow pointed at
the ionizer. Connect the 1/4 inch hose with dust filter to Tap Water Inlet on the bottom of
the ionizer. Pull firmly to check to connection - you should not be able to pull the hose out.
Join the cable connector from the faucet to the Connect Wire. Plug the Connector Cord into the
Connector Plug on the back of the ionizer.
Connect the power cord into an appropriate outlet.
4
5
6
7
8
9