Primex BASIC User manual

INSTRUCTIONS
Primex GmbH, Senefelder Str. 12, 63456 Hanau/Germany, Tel.: (+49) - 61 81 - 67 16 0
www.primex-interior.com
08.2017
WALL FRAME BASIC 19 mm
ITEMS DELIVERED YOU NEED ADDITIONALLY
• 4 profile pieces with holes for wallmounting • slotted screwdiver
• 4 locks without holes • screws/dowels
• 4 locks with holes/screws
• (textile print with rubber lip all around)
STEP 1 Connect corner
Place a lock without holes under a lock with holes/screws.
Take a profile piece and put the locks in the according rail in the profile.
Put another profile piece on the lock.
STEP 2 Connect all profiles and corners
Repeat step 2 with all locks and profile pieces.
Equip the last profile piece with the 4 left locks and put it on the 3 already
mounted profiles.
STEP 3 Tighten all locks and screws
Put the frame on an even ground and tighten all screws of the locks with a
slotted screwdriver.

INSTRUCTIONS
Primex GmbH, Senefelder Str. 12, 63456 Hanau/Germany, Tel.: (+49) - 61 81 - 67 16 0
www.primex-interior.com
08.2017
STEP 4 Fix the frame to the wall
Hold the frame on the wall and mark the spots for the drillings with a pencil.
Drill the holes into the wall and put the corresponding dowels in.
Then fix the frame with screws.
STEP 5 Insert textile
Insert the textile with the rubber lip into the according notch of the frame.
Make sure that you hold the rubber lip right, since otherwise the textile will not
fit in the frame: Fold the rubber lip slightly inwards (90°) and put it into the
notch (see image).
Note regarding the wall mounting:
Depending on the wall conditions, different screws and dowels are necessary. Please check before
mounting which mounting materials are suitable for your wall.