Procom Lost River PCILVFD18-1 User manual

VENT-FREE GAS LOGS
INSTALLATION INSTRUCTIONS
MODELS
PCILVFD18-(1,2) & PCILVFD24-(1,2)
For Use With
PCILVFD(18,24)H, PCILVFD(18,24)RT and PCILVFD(18,24)T Chassis
PCILVFD18-1 Shown
Questions, problems, missing parts? Before returning to your retailer, call
our customer service department at 1-866-573-0674, 7:30 am - 4:15 pm CST,
Monday through Friday or email [e-mail]

2www.usaprocom.com 200359-01A
TABLE OF CONTENTS
Installation Guidelines ............................... 2
Installing Logs............................................ 3
Warranty .................................................... 8
SAVE THIS BOOK
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
This log set has been tested and approved to ANSI
Z21.11.2 standard for Unvented Heaters and also com-
plies with ANSI Z21.60 Decorative Vented Appliances for
Solid Fuel Burning Fireplaces. State and local codes in
some areas prohibit the use of vent-free heaters. Check
your state or local codes.
INSTALLATION GUIDELINES
Proper Log Placement
Log placement is critical to proper burner
performance. Logs must be correctly po-
sitioned onto the burner. The illustrations
in this manual show the proper position for
logs on this set. Owners need to be shown
proper log placement and instructed not to
move the logs.
Logs must t rmly onto the burner when posi-
tioned as shown in the illustrations. Malformed
logs must be replaced.
Proper Primary Airow into the
Burner
For proper burner operation and ame ap-
pearance, the ow of primary air into the
venturi tube, located on the rear of the burner,
must not be reduced. This ow of air is re-
duced if dirt, lint or other obstructions build-up
around or inside the venturi. Any obstruction
in the venturi tube area must be removed.
The ow of air into the venturi is also reduced
if the gas orice isn't centered in the venturi
inlet and/or is not aligned with the venturi. Any
misalignment of the burner orice may be cor-
rected by bending the shutter cap holding the
orice to the inlet or the venturi tube.
Ceiling Fans, Portable Fans or Logs
Installed Near Cold Air Returns
Ceiling fans or oscillating oor type fans need
to be monitored during the operation of vent-
free logs. If the air blows directly into the ame
causing it to impinge on the log set, or rebox,
it should be turned off or redirected. Ceiling
fans could be reversed to possibly eliminate
ame impingement, and the oor fan could be
redirected. Upon installation, be aware of any
cold air returns or vents in the proximity of the
log set. Any draft created around a vent-free
log set can cause the ame to impinge on the
log and create a sooting situation.
Candles
Avoid the use of scented or decorative can-
dles while the log set is in operation. Candles
produce a residue in the air that creates a soot
like substance. Burning candles while the
log set is operating magnies the problem.
It should be noted that candles, in general,
produce soot. The amount of time burned and
the quantity of candles burned will determine
the amount of soot produced and deposited.
Proper Log Set Operation
Properly installed and properly maintained log
sets do not deposit soot on the logs. If users
see soot appear on a log, call for service. Do
not continue to operate the log set.

3
www.usaprocom.com
200359-01A
Sunken Fireplace
If installing this unit into a sunken replace,
you must raise the oor to insure adequate
airow and guard against sooting. Raise re-
place oor using a noncombustible material,
which is secure.
Glass Doors
Make sure that glass doors are open during
all operations of the log set. The opening of
the glass door frame should be the dimen-
sion used for the minimum front opening of
the rebox.
Wood Burning Fireplaces
The interior of the rebox and the chimney
should be cleaned and free of all creosote be-
fore installing a gas burning log set. Creosote
will soften when heated and can drop on the
log set causing odors and possibly sooting.
INSTALLATION GUIDELINES
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation
and periodically thereafter,
check to ensure that no yellow
ame comes in contact with any
log. With the heater set to High,
check to see if yellow ames
contact any log. If so, reposi-
tion logs according to the log
installation instructions in this
manual. Yellow ames contact-
ing logs will create soot.
Rear Log Bracket
Middle Log
Bracket
Front Log Bracket
PCILVFD18RT Chassis Shown. Actual model may vary.
Do not attempt to use this heater if any logs
are missing or damaged.
Inspect the contents of this log set to insure
there are no missing or damaged logs. If any
logs are found missing or damaged contact
customer support for replacements.
It is very important to install the logs exactly
as instructed. Do not modify logs. Use only
logs supplied with heater.
Each log is marked with a number. This number
will help you to identify the logs when installing.
After installing logs, add decorative cinders
around the grate base, do not place any
decorative cinders on logs or burner.
NOTE: During initial operation of a new heat-
er, burning logs will give off a paper-burning
smell. Orange ame will also be present.
Open damper or window to vent smell. This
will only last a few hours.
Each of the following pages contains a list
of replaceable parts for each log set. When
ordering parts, contact authorized dealers
of this product or call customer service at
1-866-573-0674. When calling have you
model and serial numbers available.

4www.usaprocom.com 200359-01A
Log #1
Log #6
Log #5
Log #2
Log #4
Log #3
MODEL PCILVFD18-1
1. Place log #1 onto rear log bracket.
2. Place log #2 onto middle log bracket.
3. Place log #3 onto front log bracket.
4. Place log #4 onto the left of logs #1, #2
and #3.
5. Place log #5 onto logs #2 and #3.
6. Place log #6 onto logs #1 and #2.
INSTALLING LOGS
ITEM PCILVFD18-1 DESCRIPTION QTY
161940-01 Traditional Log Set 1
1161941-01 Bottom Rear Log 1
2161942-01 Bottom Middle Log 1
3 161943-01 Bottom Front Log 1
4 161944-01 Top Left Log 1
5 161946-01 Top Right Log 1
6 161945-01 Top Middle Log 1

5
www.usaprocom.com
200359-01A
INSTALLING LOGS
MODEL PCILVFD18-2
1. Place log #1 onto rear log bracket.
2. Place log #2 onto middle log bracket.
3. Place logs #3 and #4 onto front log
bracket.
4. Place log #5 onto the left of logs #1, #2
and #3.
6. Place log #6 onto logs #2 and #4.
5. Place log #7 onto logs #1 and #2.
Log #1
Log #7
Log #6
Log #4
Log #2
Log #5
Log #3
ITEM PCILVFD18-2 DESCRIPTION QTY
161947-01 Split Log Set 1
1161948-01 Bottom Rear Log 1
2161949-01 Bottom Middle Log 1
3 161950-01 Bottom Front Left Log 1
4 161951-01 Bottom Front Right Log 1
5 161944-01 Top Left Log 1
6 161946-01 Top Right Log 1
7 161945-01 Top Middle Log 1

6www.usaprocom.com 200359-01A
INSTALLING LOGS
Log #1
Log #6
Log #7
Log #2
Log #4 Log #5
Log #3
MODEL PCILVFD24-1
1. Place log #1 onto rear log bracket.
2. Place log #2 onto middle log bracket.
3. Place log #3 onto front log bracket.
4. Place log #4 onto the left of logs #1, #2
and #3.
5. Place log #5 onto logs #2 and #3.
6. Place log #6 onto logs #2 and #3.
7. Place log #7 onto logs #1 and #2.
ITEM PCILVFD24-1 DESCRIPTION QTY
161952-01 Traditional Log Set 1
1161953-01 Bottom Rear Log 1
2161954-01 Bottom Middle Log 1
3 161955-01 Bottom Front Log 1
4 161944-01 Top Left Log 1
5 161956-01 Top Middle Log 1
6 161945-01 Top Right Log 1
7 161946-01 Top Crossover Log 1

7
www.usaprocom.com
200359-01A
INSTALLING LOGS
MODEL PCILVFD24-2
1. Place log #1 onto rear log bracket.
2. Place log #2 onto middle log bracket.
3. Place logs #3 and #4 onto front log bracket.
4. Place log #5 onto the left of logs #1, #2
and #3.
5. Place log #6 onto logs #2, #3 and #4.
6. Place log #7 onto logs #2 and #4.
7. Place log #8 onto logs #1 and #2.
Log #1
Log #7
Log #8
Log #2
Log #5 Log #6
Log #3 Log #4
ITEM PCILVFD24-2 DESCRIPTION QTY
161957-01 Split Log Set 1
1161958-01 Bottom Rear Log 1
2161959-01 Bottom Middle Log 1
3 161960-01 Bottom Front Left Log 1
4 161961-01 Bottom Front Right Log 1
5 161944-01 Top Left Log 1
6 161962-01 Top Middle Log 1
7 161945-01 Top Right Log 1
8 161946-01 Top Crossover Log 1

200359-01
Rev. A
10/16
WARRANTY
KEEP THIS WARRANTY
Model _______________________________
Serial No. ____________________________
Date Purchased _______________________
Keep receipt for warranty verication.
ProCom Heating, Inc.
Bowling Green, KY 42101
www.usaprocom.com
1-866-573-0674
REGISTER YOUR PRODUCT AT WWW.USAPROCOM.COM
IMPORTANT: We urge you to register your product within 10 days of date of installation, complete
with entire serial number which can be found on the rating plate. Please ll out the warranty infor-
mation above for your personal records. Retain this manual for future reference.
Always specify model and serial numbers when communicating with customer service.
We reserve the right to amend these specications at any time without notice. The only warranty applicable
is our standard written warranty. We make no other warranty, expressed or implied.
LIMITED WARRANTY
ProCom Heating, Inc. warrants this product to be free from defects in materials and components for ONE
(1) year from the date of rst purchase, provided that the product has been properly installed by a qualied
installer in accordance with all local codes and instructions furnished with the unit, operated and main-
tained in accordance with all applicable instructions. To make a claim under this warranty, the Bill of Sale
or canceled check must be presented.
RESPONSIBILITY OF OWNER
This warranty is extended only to the original retail purchaser. This warranty covers the cost of part(s)
required to restore this heater to proper operating condition. Warranty part(s) MUST be obtained through
ProCom Heating, Inc. who will provide original factory replacement parts. Failure to use original factory
replacement parts voids this warranty.
IMPORTANT: The heater MUST be installed by a qualied installer in accordance with all local codes
and instructions furnished with the unit or the warranty is voided.
WHAT IS NOT COVERED
This warranty does not apply to parts that are not in original condition because of normal wear and tear or
parts that fail or become damaged as a result of misuse, accidents, lack of proper maintenance or defects
caused by improper installation. Travel, diagnostic cost, labor, transportation and any and all such other
costs related to repairing a defective heater will be the responsibility of the owner.
TO THE FULL EXTENT ALLOWED BY THE LAW OF THE JURISDICTION THAT GOVERNS THE SALE
OF THE PRODUCT, THIS EXPRESS WARRANTY EXCLUDES ANY AND ALL OTHER EXPRESSED
WARRANTIES AND LIMITS THE DURATION OF ANY AND ALL IMPLIED WARRANTIES. INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE TO ONE (1)
YEAR ON ALL COMPONENTS FROM THE DATE OF FIRST PURCHASE. PROCOM HEATING, INC.'S
LIABILITY IS HEREBY LIMITED TO THE PURCHASE PRICE OF THE PRODUCT AND PROCOM HEAT-
ING, INC. SHALL NOT BE LIABLE FOR ANY OTHER DAMAGES WHATSOEVER INCLUDING INDIRECT.
INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Some states do not allow a limitation on how long an implied warranty lasts or an exclusion or limitation of
accidental or consequential damages, the above limitation on implied warranties, or exclusion or limitation
on damages may not apply to you.
This warranty gives you specic legal right, and you may also have other rights that vary from state to state.