Pronteau Produo PROBOIL.2 User manual

Scan here to link to a video demonstration
Scan here to link to a video demonstrationScan here to link to a video demonstration
Scan here to link to a video demonstration
 If misplaced you can download a copy
of the full user guide at www.proboil.co.uk
PROBOIL.
Descaling Guide
The filter system provided with PR B IL will help to prevent of the calcification (scaling) of the
boiler. However it will be required from time to time that the PR B IL will need to be descaled,
drained and refilled to ensure the maximum energy efficiency and service life from the product
especially in hard water areas. Descaling solutions can be obtained by contacting the service
agent shown on the label on top of the boiler or via www.proboil.co.uk
Ensuring that the filter system is set up correctly and replaced as required will
reduce the frequency of descaling required. If you are regularly needing to descale
the PR B IL system then you either need to replace the filter more frequently or
check the setup of the filter system.
WARNING:
WARNING:WARNING:
WARNING: Harmful if swallowed. Irritating to eyes and skin. KEEP UT F REACH F
KEEP UT F REACH F KEEP UT F REACH F
KEEP UT F REACH F
CHILDREN
CHILDRENCHILDREN
CHILDREN. Avoid contact with skin and eyes. In case of contact with eyes, rinse
immediately with plenty of water and seek medical advice. After contact with skin,
wash immediately with plenty of water. If swallowed, seek medical advice immediately
and show this container or label.
Ingredients: Sulfamic Acid. Country of origin USA. See www.proboil.co.uk for further
information and SDS.
⚠ The descaling chemical is acidic and should only be used and handled as indicated, care
should be taken not to ingest, expose to skin, clothing or decorative surfaces. Take care
when touching all surfaces and when disconnecting or connecting hoses they may be hot
and or generate steam, you must use personal protective wear to prevent accidental
scalding.

Proboil.2
Proboil.2 Proboil.2
Proboil.2 –
––
– Descaling Guide
Descaling GuideDescaling Guide
Descaling Guide
1. Turn power off, take
plug out
2. Turn on tap until water
runs cold, then fully turn
off
3. Firmly pull up rubber hose
(a) collar (c) down and pull
pipe (b) out simultaneously.
Prepare for small spillage.
Remove to bench (if desired)
4. pen drain on front of
unit.
5. Drain fully into a suitable
container or sink.
6. Lift away lid & knob (d) and
styrene insulation (e).
7. Unscrew tank lid ring
anti-clockwise.
8. Lever lid upwards using
screwdriver under 3 x lugs.
9. Lift lid and rinse out tank
with clean cold water.
10. Add 1 x bottle of
descaler (2 x descaler
if heavily scaled).
!CAUTI N! Take care
not to damage tube
inside boiler tank.
11. Replace tank lid, ensure
arrow is to rear as
shown.
12. Push lid level back onto
body as shown.

13. Lid fits flush with
tank when fully
fitted.
14. Fully fasten tank lid ring
clockwise.
15. Lower lid & knob (d) and
styrene insulation (e).
16. Loosely rotate
temperature knob
until it drops then
press down.
17. Push rubber hose (a) and
pipe (b) fully onto stems
as shown. Return unit to
former position.
18. Turn on until water runs
through spout, then fully
turn off.
19. Plug the boiler in at
the mains.
20. Plug in, and turn power
on.
21. Wait 20 minutes for unit
to boil (max 30 mins).
22. Turn on water and
flush through at least
5 litres. Should any
taste persist repeat
steps 22 & 23.
23. Wait 12 minutes for unit
to re-boil.
24. Re-calibrate temperature
knob if necessary. See
user manual for details,
or visit
www.proboil.co.uk