pureguardian H2000 Quick reference guide

E-1
pureguardian®
72-Hour Ultrasonic
Humidier
Model No. H2000
3-Year Limited Warranty
www.guardiantechnologies.com
1.866.603.5900
REV0411
English E - 1
French F - 1
Spanish S - 1
Date Purchased
month ________
year _________
USE & CARE INSTRUCTIONS

E-2 E-3
READ AND SAVE THIS MANUAL
Model Number: H2000
Humidifying Mode: Combination
Power Supply: AC120V, 60Hz
Power Consumption: 140W (40W at cold humidication)
Maximum Humidity Capacity: About 350cc/Hr (at highest setting and warm humidication)
Tank Capacity: 1.4 gallons
Successive Humidity Hours: Up to approximately 72 hours depending on environmental conditions
Dimensions: Width - 14.5 inches; Length - 9 inches; Height - 12 inches
Weight: 6 pounds (not including packaging)
SPECIFICATIONS
PARTS
Tank Lid
Cleaning Brush
Power Plug
Humidity Dial
Mode Dial
Body Rell LED
Power LED
Air-Cleaning
Filter
Spout Guide
Tank
Handle
Humidity
Spray Spout
Warm or Cold Humidication Selection
Select humidifying temperature based on need. Warm humidity will use more
power but will humidify your room quicker.
Water Shortage Indicator
When the unit is low on water the Rell LED on the front panel will light up, and
the unit will automatically shut off. Simply add more water to continue use.
Humidity Adjustment
The humidity volume may be adjusted based on need by using the humidity dial
on the front panel.
Silver Clean Technology
Unlike other humidiers that grow slimy mold and mildew, the pureguardian Ultra-
sonic Humidier uses Silver Clean technology embedded in the tank to
ght the growth of mildew and mold on the surface of the water tank.
To access
cleaning brush,
pull up on lid.

E-3 E-5
This product should be used only in accordance with the specications outlined in this manual.
Usage other than what has been specied here may result in serious injury.
• Disassembly, repair or remodeling by an unauthorized person may result in serious harm.
• Do not use if plug is damaged or loose.
• Keep this product out of the reach of children and pets.
• Be careful not to put water in the humidity spout.
• Before lling or cleaning the unit, make sure it is unplugged.
• Once the humidier has been turned on, do not move it.
• Do not remove the water tank from the unit while it is on.
• Do not handle the plug with wet hands.
• Do not excessively bend, twist or pull the power cord.
• Avoid placing this product where the humidity spray spout is pointed directly at an object.
• Do not inhale the mist from the humidity spray spout.
• Do not place this product on a sloped or unstable surface.
• When not in use, unplug the unit.
• Do not ll the water tank with hot or boiling water.
• Do not use this product in direct sunlight or near a gas stove or heater.
• If the water tank becomes cracked or damaged do not use.
• Do not keep this product running for an extended period of time.
• Do not clean the unit of water tank with detergents or chemicals of any kind.
• Do not use this product near any other electronic device.
• Do not cover the humidity spray spout at any time during use.
• Do not use this product near a sink.
• Do not drink water from tank.
• Do not place this product on an absorbent surface.
• Children cannot recognize the hazards associated with the usage of electrical appliances.
For this reason, always supervise children when they are near the humidier.
• If the mist comes in contact with the oor prior to evaporating, the oor surface may be
damaged. We do no accept any liability for damage in the case of the unit being placed
incorrectly.
• The use of water additives, such as ethereal/essential oils, fragrances, eucalyptus, water
conditioners etc. will damage the appliance materials and as a consequence the whole
unit. Any use of such additives will void the manufacturer’s warranty.
• IMPORTANT: Neither humans nor animals can hear the high frequency vibrations.
Failure to comply with the warnings listed above may result in electric shock or serious injury.
3. Pour cool, clean water directly
into the tank.
4. Close the tank lid, turning it
to the right.
5. Attach the tank to the body
of the unit and plug in.
6. Turn the Mode Dial to either
cool or warm. The Power LED
light up.
Make sure the unit is unplugged.
1. Separate the tank from the
body of the unit.
2. Open the tank lid, turning
it to the left.
E-4

E-6 E-7
• Always unplug the unit before servicing it in any way.
• The water temperature of the water remaining in the unit after use may be high.
• Do not submerse the unit in the water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the spout guide.
Wash out the unit with fresh water, using ONLY the cleaning brush and a soft
cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft damp cloth if needed.
WATER TANK
If water spots remain in the water tank, wipe the inside down with a soft cloth.
Do not use soap or detergents.
AIR FILTER
Gently wipe away debris from the lter with a soft cloth.
ULTRASONIC DISK
Remove spray spout (Fig. 1) and use the enclosed cleaning brush to regularly
remove build up and deposits from this area (Fig. 2). Diluted white vinegar will
help to prevent this build up.
• Fully dry the inside and outside of the unit before storing it.
• DO NOT leave water in the unit.
• Store in a cool, dry place.
PROBLEM SOLUTION
Water mist & humidity are not
produced.
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Tank Installation: Make sure the tank is
correctly attached.
Air blows but water mist is not
produced.
Excessive Water: Remove a certain amount of water
from the tank.
The desired humidity is lower than the current
temperature: Increase the desired humidity.
Detergent residue in tank: Wash the tank
out and try again.
Humidity level is low. The surface of the ultrasonic disk is dirty: Wipe it off
with a soft, dry cloth. Clean with white vinegar.
The water in the unit is too cold: Replace with cool, but
not cold water.
Damage on the ultrasonic disk: Exchange the disk.
Warm humidity is not produced. It may take 10-15 minutes before warm humidity
is created.
Check to see if base of unit feels warm to the touch.
If so warm mist is being produced.
The humidity has a bad smell. Poor maintenance or dirty water: Clean the product
thoroughly, and ll it with fresh water.
White dust is forming on nearby
furniture.
Hard water may deposit a certain amount of dust. Dust
in the air also settles because of added humidity in the
room. Use distilled water if this becomes a nuisance.
Or order a Decalcication Filter (FLTDC)
by calling 1.866.603.5900 or
visiting www.guardiantechnologies.com.
7. Turn the Humidity Dial to the desired
volume of humidity. Toward the right and
the humidity level increases; toward the
left and the humidity level decreases.
8. As soon as the Rell LED lights
up, turn the unit off and rell the
water tank.
**Clean the disk with
the brush ONLY. No
other cleaning tool
should be used.
BRUSH ONLY. (Fig. 2)

E-7 E-8
To the consumer, Guardian Technologies LLC warrants this product to be free of
defects in materials or workmanship commencing upon the date of the original
purchase. Save your original sales receipt to validate start of warranty period.
If this product should become defective within the warranty period, we will
repair or replace any defective parts free of charge. The complete machine must be
delivered pre-paid to any authorized Guardian Technologies LLC warranty service
center. Please include complete information on the problem, day of purchase, copy
of original sales receipt and your name, address and telephone number. If you are
not near a warranty station, call the factory for assistance in the US and Canada at
1.866.603.5900. Use only genuine Guardian Technologies replacement parts.
The warranty does not include unusual wear, damage resulting from accident, or
unreasonable use of the product. This warranty does not cover unauthorized repairs.
This warranty gives you specic legal rights and you may also have other rights
(other rights may vary from state to state in the U.S.A.).
We consider the registration process important to ensuring superior service to our
customers, however submitting this card to Guardian Technologies LLC is optional
and does not affect your rights to utilize this warranty according to the conditions
stated above. If you have any questions or comments about our product call toll free
at: 1.866.603.5900, or send comments to: ATTN: Customer Service
Guardian Technologies LLC
7700 St. Clair Avenue
Mentor, Ohio 44060
Guardian Technologies LLC
7700 St Clair Avenue | Mentor, Ohio 44060
1.866.603.5900 | www.guardiantechnologies.com
©2007 Guardian Technologies LLC
Product warranty can also be registered online at www.guardiantechnologies.com.
This product has been tested and complies with the requirements
for Federal Communications Commission, Part 18 for Radio/TV/
Communication interference. Although tested, it may affect these
devices. If the humidier is found to interfere, separate the device
and/or the humidier. Conduct only the user maintenance found in
this manual. Other maintenance and servicing can cause harmful
interference and can void the required FCC compliance.