PureMounts PM-WIRE-37 User manual

ISSUED: SEPT. 2013
50kg
(110bs)
RATED
50kg
(110bs)
RATED
200x200
200x200/300x300
400x200/400x400
CAUTION: DO NOT EXCEED
RATED LISTED WEIGHT. SERIOUS
INJURY OR PROPERTY DAMAGE
MAY OCCUR!
42"
MAX
55"
MAX
TV Wall Mount
INSTALLATION MANUAL
PM-WIRE-37
PM-WIRE-52

21
Package M
Package W
1
NOTE: Read the entire instruction manual before you start installation and assembly. Component Checklist
WARNING
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, telephone your local distributor for a replacement.
supporting spacer (x1)
D
supporting spacer (x1)
C
(x1)
B
adapter bracket
wall plate
A
(x2)
ST5.5x50 (x2)
W-A
concrete anchor
W-B
(x2) D6 washer
W-C
(x2)
M5x14
M-A
(x4) M6x14
M-B
(x4) M8x20
M-C
(x4) M6x30
M-D
(x4)
M8x30
M-E
(x4) big spacer
M-I
(x4)small spacer
M-H
(x8)D5
M-F
washer(x4) D8
M-G
washer(x4)
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• This product should only be installed by someone with good mechanical ability
who has basic building experience and fully understands this manual.
• Make sure that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.

3 4
1. For Solid Brick and Concrete Mounting
60mm
(2.4")
60mm
(2.4")
ø 8mm
(ø 5/16")
Drill pilot holes
2
Mark the
exact location of
mounting holes
WARNING
Installers must verify that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
X X
√
W-B
W-C
W-A
2. Installing the Adapter Brackets
2-1 For Flat Back Screens
Top of the TV
M-F
M-G
M-A
M-B
M-C
M-A
M-B
M-C
M-F
M-G
TV
TV
TV
1
PM-WIRE-37(60-120mm)
PM-WIRE-52(180-220mm)

2-2 For Bump-out or Recessed Back Screens
Tighten all screws but do not over tighten.
· Screw the supporting spacers onto the TV.
Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen.
56
3. Hanging the TV onto the Wall Plate
Maintenance
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).
• Please contact your distributor if you have any questions.
After the wall mount has been safely secured to the wall, Carefully lift your TV and hook wirerope into the
wall plate rail. Make sure your TV is securely and correctly attached.
4. Cable Management
•
• Fold the tilt supports back once all cables have been installed.
Fold out the tilt supports to access the cables.
TV
TV
TV
M-H M-G
M-C M-G
M-C
M-D
M-E
M-H
M-G
M-D
M-E
M-I M-G
M-D
M-E
M-I
M-H
or
M-H M-H
M-I
M-H
or
M-I
M-G M-C M-G
M-C
M-D
M-E
M-G M-D
M-E M-G M-D
M-E