QSC TSC-50t-G3 User manual

™
Quick Start Guide
Tabletop Stand Accessory
TSC-50t-G3 (for TSC-50-G3)
TSC-710t-G3 (for TSC-70-G3 or TSC-101-G3)
Warranty
For a copy of the QSC Limited Warranty, visit the QSC, LLC., website at www.qsc.com.
Tabletop Features
• Tool-less assembly • Portrait and landscape
configurations
• Movable or fixed installation
options
• Non-skid, low profile
design
Specifications
• Dimensioned drawings and product specifications available online at www.qsc.com.
• QSC recommends using a category cable without a moulded strain relief boot. Refer to the
Hardware User Manual for other cable requirements.
Yes No
Movable Installation TSC-50t-G3 / TSC-710t-G3
Caution: Do not attempt to assemble or disassemble the stand while the touch
screen controller is attached.
1 Orient Docking Plate
1 (TSC-50t-G3 Only)
4 Install Base
5 Connect Cable to
6 Touchscreen Controller
2Remove Base
2(Method 1)
3 Route Cable
(Method 2)
®
QSC Self Help Portal
Read knowledge base articles and discussions, download software and firmware,
view product documents and training videos, and create support cases.
https://qscprod.force.com/selfhelpportal/s/
Customer Support
Refer to the Contact Us page on the QSC website for Technical Support and
Customer Care, including their phone numbers and hours of operation.
https://www.qsc.com/contact-us/
© 2021 QSC, LLC. All rights reserved. QSC, the QSC logo, Q-SYS, and the Q-SYS logo are registered trademarks of
QSC, LLC, in the U.S. Patent and Trademark office and other countries. Q-LAN and Q-SYS Designer are trademarks of
QSC, LLC. Patents may apply or be pending.
All other trademarks are the property of their respective owners.
http://patents.qsc.com
TSC-50t-G3
Fixed Installation Movable Installation
TSC-710t-G3
Landscape
(Default)
Rotate CW 90°
(Portrait)
TD-001620-01-A
*TD-001620-01*
32

1 Orient Docking Plate
1 (TSC-50t-G3 Only)
2Drill Hole
1-1/16" min.
3Install Threaded Pipe
3/4" NPS
Fixed Installation TSC-50t-G3 / TSC-710t-G3
User Supplied Parts
These parts are required only for the fixed installation.
Mounting Pipe (3/4" NPS)
Rubber/Foam Washer (Optional)
1x 1x
1x or 2x
Lock/Jam Nut (or Similar)
Assembly and Installation (continued)
6Assemble Touchscreen
Controller to Stand
Assembly and Installation
5Connect Cable to
Touchscreen Controller
4Route Cable
Washer (optional)
Lock/Jam Nut
Landscape
(Default)
Rotate CW 90°
(Portrait)
4 5
67