
Step 3: Install DD1 / DD2
Hardware:
● 1 x DD1/DD2 (purchased separately)
● 4 x 20mm LONG Bolts
Hold DD1/DD2 in place. Screw in each 20mm LONG side bolt until they are slightly tight,
while keeping the DD1/DD2 centered in the gap between the side mount profiles.
In other words, the DD1/DD2 will stay in place, while the side mounts slide towards the
middle as you tighten the 20mm LONG bolts.
Adjust the Angle of tilt of the DD1/DD2. Once you are happy, fully tighten the 20mm
LONG bolts into the DD1/DD2 and then finally fully tighten the 8 x 16mm Standard Bolts.
Page 5
RCP DD1/DD2 Side Mount Manual (v.08/2021.1)