RecPro RP-RH-22-BL User manual

INSTRUCTION MANUAL
Hood
Models: RP-RH-22-BL/SS

Introduction
is
a
s
to
Washing Method
a a
to a to
an a
to on
soak it in a mix
to
Assembly Warnings
not to
is
|

Safety Warnings
1. Children are not to operate the range hood. (Risk of electric shock or bodily harm)
2. Do not remove the filters when the hood is in use. (Risk of bodily harm from
motor)
3. Be sure that any changes, repairs, or removal of range hood done by someone
with a full understanding of the hood functions and limitations. (Risk of electric
shock or fire)
4. Do not put your hands into the range hood when filters removed for washing.
(Risk of electric shock or bodily harm)
5. Do not use benzene, acetone or thinner to clean.
6. If you suspect gas has leaked or is in the surrounding area, do not touch the
range hood. Please insure the air is circulating and the gas dissipates before
resume use of hood. (Risk of spark, a blast, or fire).
7. Make sure power off when washing any part of the range hood. (Risk of
electric shock or fire)
8. Do not attempt any repairs if the power cord is broken or damaged. Connect the
manufacture immediately for repair. (Risk of electric shock or fire)
9. Please insure proper air ventilation when gas burners are in use. (Rick of fire)
10. Please clean the range hood intermittently and use the correct method provided
in this manual. (Risk of fire)
3|Page

LED Light Changing Method
Disconnect power and unplug the power cord before performing any other steps.
1. Remove light cover to change the proper LED light bar.
2. Fasten the LED light bar to the metal cover with double sided adhesive tape.
3. Reattach the lamp cover to the range hood. Make sure the location on the
lamp against the LED bar surface to prevent it from being a loose connection.
This appliance uses DC 12V storage battery as a power supply.
Exposed red line is "positive pole". Exposed white line is "negative pole(-)".
Battery must be connected by someone who has knowledge of the range hood.
Installation method diagram shown below.
4|Page
22
"
17¾
"
9⅝
"
11⅜
"
21
"
7½
"
18
"

Fan Motor Rating: 12V DC 0.8A
LED Lamp Rating: 12V DC 0.16A
Fuse Rating: SA
This unit needs a 19.5 inch clearance when installing.
Important Safety Instructions READ AND SAVE THESE
INSTRUCTIONS WARNING- To reduce the rise of fire, electric shock,
or injury to persons, observe the following:
A) Use this unit only in the manner intended by the manufacturer. If you have
any questions, contact the manufacturer.
B) Before servicing or cleaning the unit, switch power off or prevent power from
being switched accidentally.
CAUTION- For general ventilating use only. Do not use to
exhaust hazardous or explosive materials and vapors.
WARNING- To reduce the risk of a grease fire:
A) Never leave surface units unattended. Boil overs cause smoking. Greasy spill
overs may ignite. Heat oil slowly on low or medium settings.
B) Always turn hood on when cooking on high heat.
C) Clean ventilation fans frequently. Grease should not accumulate on fan or
filter.
D) Use proper pan size. Always use cookware appropriate for the size of the
surface element.
5|Page

A)
B) Y
C) A
ABC
6|Page

806 S. Division St.
Bristol, IN 46507
[phone]
[email protected]