Redarc LBATMB-001 User manual

Battery Mounting Bracket
LBATMB-001
Suitable for Alpha 150 LiFePO4Battery
LBAT12150-SB

WARNINGS AND SAFETY INFORMATION
SAVE THESE INSTRUCTIONS — This manual contains important safety instructions. Do not install the LBATMB-001
Mounting Bracket unless you have read and understood this manual. REDARC recommends that the Mounting
Bracket referenced in this manual be installed by a suitably qualied person.
Disclaimer: REDARC accepts no liability for any injury, loss or property damage which may occur from the improper
or unsafe installation or use of its products.
SAFETY MESSAGE CONVENTIONS
Safety messages in this manual contain a signal word that indicates the level of the hazard, as follows:
WARNING Indicates a potentially hazardous situation which could result in death or serious injury to
the operator or to bystanders.
CAUTION Indicates a potentially hazardous situation which may result in moderate or minor injury to
the operator or to bystanders.
NOTICE Indicates a situation that may cause equipment damage.
MOUNTING REQUIREMENTS
IMPORTANT: DO NOT install the Battery in the engine bay, this Product is not designed to operate in engine
bay environments.
Mount the Lithium Battery permanently to a xed surface that has adequate strength to support it when all
connections and wiring are in place. DO NOT mount on any moveable parts.
The mounting surface must be at and safe to drill through — check the reverse side before drilling.
Mount in a location where the Status LED on the Battery is visible.
Leave adequate clearance around each side of the Battery to allow for air ow.
If installing the Battery in an enclosed space, make sure there is adequate venting.
MOUNTING HARDWARE
Select appropriately sized countersunk fasteners to install the Mounting Bracket.
Ensure the selected fasteners:
Are suitable for the mounting surface and there is clearance-t
through the Mounting Holes on the Bracket.
Will not protrude the surface of the mounting bracket after
installation.
CAUTION
Do not expose the Battery to heat or re. Avoid
exposure to direct sunlight.
Keep the Battery clean and dry. Keep away from
water, dust and contamination.
NOTICE
Place the Battery in well ventilated areas.
Use Personal Protective Equipment (PPE).
Wear appropriate clothing as well
as eye protection when operating
power tools.

MOUNTING INSTRUCTIONS
MOUNTING THE BRACKET
1. Select an appropriate mounting location for
your battery (refer to 'Mounting Requirements').
2. Secure the Mounting Bracket in your selected
mounting position using appropriate
fasteners (refer to 'Mounting Hardware').
SECURING THE BATTERY TO THE MOUNTING BRACKET
1. Remove and retain the nuts, spring washers, at washers and clamp section of the Mounting Bracket.
2. Place the Battery centrally in the Mounting Bracket.
3. Align the locating features of the Battery and the Mounting Bracket.
4. Re-install the battery clamp, at washers, spring washers and nuts removed in step 1.
5. Align the battery clamp with the locating features on the Battery.
6. Torque each nut to 7 Nm (5.2 ft-lbf) to securely clamp
the Battery to the Mounting Bracket.
7. Refer to the Lithium Battery’s instruction
manual for wiring installation.

Tech Support
1300 REDARC (1300-733-272)
Australia
[phone]
New Zealand
[phone]
UK & Europe
[phone]
USA
[phone]
Canada
[phone]
Mexico
[phone]
redarcelectronics.com
INST274-1