Regal Electro BA BATEQ4 User manual

Battery Accessories
Battery Equaliser 10A Operation Manual
Version: 3 | Date: 12/3/2018 | Revised by: PSD | Date: 12/3/2020
2. Marketing/Product Specifications/Battery Accessories
OPERATION MANUAL
BA BATEQ4
4 Way Battery Equaliser 10A

Battery Accessories
Battery Equaliser 10A Operation Manual
Version: 3 | Date: 12/3/2018 | Revised by: PSD | Date: 12/3/2020
2. Marketing/Product Specifications/Battery Accessories
APPLICATION:
The BA BATEQ4 Battery Equaliser may be used on 12V lead-acid batteries which
are connected in series to maintain equal battery voltage balance.
When the batteries are connected in series, the voltages may vary due to
impedance differences, the cell chemical composition and temperature. One
battery may go high and another low so that one becomes under charged and
the other over-charged. The battery equaliser will equalise/balance the battery
voltage when it detects there is more than 20mV voltage difference between
two batteries. It will shunt current from one battery (the higher voltage one) to
the other battery (the lower voltage one). Until their battery voltage are both
20mV of each other. This will improve battery’s performance and extend battery
life.
The BA BATEQ4 Battery equaliser may be used for 24V, 36V, 48V and any other
12V battery system. The BA BATEQ4 can equalise up to 4 cells/batteries.
TECHNICAL DATA:
Battery Nominal Voltage
4* (2.4V/3.6V/6V/9V/12V)
Optimising Current
0-10A
Quiescent Current
5mA (12V) 1.2mA (2.4V)
Dimensions
62 x 124 x 27mm
Protection
Reverse Polarity Protection
Low Voltage Disconnect
1.8V
Reorder Code
BA BATEQ4

Battery Accessories
Battery Equaliser 10A Operation Manual
Version: 3 | Date: 12/3/2018 | Revised by: PSD | Date: 12/3/2020
2. Marketing/Product Specifications/Battery Accessories
INSTALLATION:
Connect the BA BATEQ4 Battery Equaliser in the following order:
1. Red cable connect to the positive (+) pole. Black cable connect to the
negative (-) pole.
2. Connect the batteries as the pictures display below on page 4.
3. Unused leads may either be left in their insulators, or cut off and
reinsulated.
4. When using multiple equalisers in a single battery system, one pair of
each equaliser needs to be shared/paralleled to maintain equal
voltage throughout the battery string.
SUGGESTION: Connect all (+) pole firstly, then (-) pole to avoid short circuits.
PLEASE NOTE! All cables must be connected because if they’re not, the
equaliser will always think that there is a battery in the string at 0V and will
attempt to charge it.
DISCLAIMER OF LIABILITY:
Please read instructions carefully and keep them. This user manual contains
product specification and operating instructions. We assume no responsibility
resulting from incorrect installation or incorrect usage. Nor will we be liable for
any costs or losses.

Battery Accessories
Battery Equaliser 10A Operation Manual
Version: 3 | Date: 12/3/2018 | Revised by: PSD | Date: 12/3/2020
2. Marketing/Product Specifications/Battery Accessories
FOR FURTHER TECHNICAL
SUPPORT PLEASE CONTACT
THE REGAL ELECTRO TEAM ON:
1300 734 253
[email protected]m.au
BA BATEQ4
+
-
+
-
+
-
+
-
BA BATEQ4
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-