Remaco AVA-361-RX User manual

Installation Guide (For AVA-361-RX)
CCOPYRIGHTS 1998 REMACO TECHNOLOGIES PTE LTD Website: www.remacotech.com
AVA-361-RX
V: 1.0
All controls support 230V/50Hz & 120V/60Hz
433MHz
AVA-361
Receiver
AVA-361-Rx
Motorized
Roller Shutter
AVA-361-Rx
Motorized
Roller Shutter
5-channel
RF remote
single channel
RF remote 5
One channel of emitter can control 20 receivers at most at the same time.
One AVA-361 Receiver maximum can
store 20 channels, over 20 channels,
if still need add new channels, it will
be repeating covered in turn from
the second channel.
Receiver in the mode of dot function, press up key and down key within
2 seconds, emitter control motor working in dot function; if continuous
press more than 2 seconds motor will last working.
Group control channel match code is unworkable.
L1
L 2
20cm
230V / 50Hz or
120V / 60Hz according
to product nameplate
230V / 50Hz
Blue = Neutral
Brown = Direction 2
Black = Direction 1
Green / Yellow = Earth 120V / 60Hz
White = Neutral
Black = Direction 2
Red = Direction 1
Green = Earth
230AV / 50Hz
120AV / 60Hz
200m
200m
35m
35m 433 MHZ
L1 Open L2 Partition Emission frequency
Circuit installation
M
C
N
L
AVA-361-Rx
Mini Box Receiver
AVA-310-RF
1 Channel
Technical Support Control Range

Switch off
T > 10s
the interval of re-
switch on must
over 10 seconds
Switch on
the interval of re-
switch on must
less 10 seconds
T < 10s
the motor
buzzes twice
Press the P2 button for
twice continuously
Press up button once,
the motor will buzz several times
Press down button once,
the motor will buzz several times
The interval time to press
different button must
1s<T<6s for all setting,
Set up is ok
The down button control
the motor clockwise
Set up is ok
The up button control
the motor clockwise
The interval time to press
different button must
1s<T<6s for all setting,
Switch on st
press(1 remote)
setting button
two time
nd
press(2 remote)
setting button
one time
Emitter
adding is ok
Switch on
Switch on
press setting button
one time (P2)
press UP button
one time
press setting button
one time (P2)
Hear Buzz...
Once press the up or limit
button, the motor will go
upwards or downwards 1/36 circle
Dot-move setting is ok
repeat setting,
function is cancelled
press setting button
one time (P2)
press STOP button
one time
press setting button
one time (P2)
Hear Buzz...
cancel emitter is ok
Delete all remote and
receiver memory
Programming Radio-Frequency Remote
Adding Second Remote
Dot-move setting
Delete Remote and Receiver Memory