Remington Power Pro User manual

2 YEAR WARRANTY
To register your product go to
remington-products.com.au
remington.co.nz
HC9000AU
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
POWER PRO
GROOMING KIT

2
IMPORTANT SAFETY INSTRUCTIONS FOR THE HAIR CLIPPER
When using an electric appliance, basic safety precautions should
always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
CAUTION: Keep the power adaptor away from water.
DANGER: As with most electrical appliances, electrical parts are
electrically live even when the switch is off.
WARNING: To reduce the risk of burns, fire, electric shock or
injuries please follow the below instructions.
• Do not reach for an appliance that has fallen into water. Unplug it
immediately.
• Do not use while bathing or in the shower. Do not place or drop
into water or other liquid.
• Do not place or store this appliance where it can fall or be pulled
into a bath or sink.
• Except when charging, always unplug this appliance from the
electrical outlet immediately after using. Unplug this appliance
before cleaning it.
• This appliance is for household use only.
• An appliance should never be left unattended when it’s plugged in,
except when charging a rechargeable appliance.
• This appliance should not be used by children or other persons
with reduced physical, sensory or mental capabilities or lack
of experience and knowledge unless they have been given
supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
• This appliance is not a toy. Children shall be supervised to ensure
they do not play with the appliance. Cleaning and use maintenance
shall not be made by children without supervision.
• Keep the appliance and the power cord away from edge of tables
or counter tops and out of reach of children and persons with
reduced physical, sensory or mental capabilities.

3
• Use this appliance only for its intended use as described in this
manual.
• Do not use attachments not recommended by Remington.
• Keep the cord away from heated surfaces.
• Never operate this appliance if it has a damaged cord or plug, if it
is not working properly, if it has been dropped or damaged, or if it
has been dropped into water. If any of these things happen, return
the appliance to an authorised service centre for examination and
repair.
• Never drop or insert any object into any of the appliance’s
openings.
• Do not use outdoors or operate where aerosol (spray) products are
being used, or where oxygen is being administered.
• Make sure the cord is disconnected from the hair clipper while
storing this appliance and cord in a moisture-free area. Do not
store it in temperatures exceeding 60°C (140°F).
• Do not use this appliance with a damaged or broken cutter unit, as
injury may occur. Always make sure blades are aligned properly.
• Always attach plug to appliance and then the adaptor to the outlet.
To disconnect, turn all controls to OFF, then remove adaptor from
outlet, then detach powercord from the hair clipper for storage.
• Do not use an extension cord or a voltage converter with this
appliance.
• Do not wrap the cord around the appliance.
WARNING - KEEP THE APPLIANCE DRY
Remington strongly recommends that an approved Safety Switch
(residual current device) be installed to protect all bathroom power
outlets. Ask an electrical contractor for advice.
SAVE THESE INSTRUCTIONS

4
HC9000AU REMINGTON POWER PRO HAIR CLIPPER
Thank you for purchasing your new Remington®Power Pro Grooming Kit. Inside this
manual you will find tips on using and caring for your hair clipper.
1. On/Off Switch
2. Comb Length Setting Indicator
3. Adjustable Comb (3-15mm)
4. Adjustable Comb (18-30mm)
5. Integrated Hair Texture Function
6. Comb Length Adjustment Wheel
7. Charging Indicator Light
Also Includes:
• Lubricating Oil
• Cleaning Brush
• Power Adaptor
KEY PARTS
3
2
4
5
6
7
1

5
ABOUT YOUR HAIR CLIPPER
HC9000AU SPECIFICATIONS
Power System Cord/Cordless
Full Charge Time 16 Hours
Run Time 45 Minutes
Indicators Charging
Worldwide Voltage Yes
Power System
Cord/Cordless – can be used with or without the power cord.
Charging Indicator
Red light that glows when the hair clipper is being charged.
Voltage Type
Worldwide Voltage – automatically adapts to an outlet voltage between 100-240V.
NOTE: Some countries will require the use of a plug adaptor that is not
included with your hair clipper.
CHARGING YOUR CLIPPER
Cordless Use
• Before using your hair clipper for the first time, charge it for 16 hours.
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains. The charging
LED light will display on the clipper.
• If the product is not going to be used for an extended period time (2-3 months),
unplug it from the mains and store.
• Fully recharge your hair clipper when you would like to use it again.
• It is not recommended to use this hair clipper directly from the power outlet when
it has been fully charged, however, while using the hair clipper in cordless mode,
if there is a noticeable drop in power, you can use the hair clipper directly from the
power outlet.
• To preserve the life of your batteries, let them run out every six months then
recharge for 24 hours.
Corded Use
• Connect the charging adaptor to the product and then to the mains.
• When the cord is connected to the mains, a charging LED light is displayed on the
hair clipper.

6
CAUTION: Extended mains (corded) only use will result in the reduction of
the battery life.
HOW TO USE
Before Starting to Cut
1. Inspect the hair clipper making sure that it is free from hair and dirt.
2. Ensure that the hair is thoroughly dry and tangle free.
3. The blades on your hair clipper should be oiled before every haircut.
Lubricating the Hair Clipper Blades
Simply place a few drops of oil on the teeth of the blades. Use only the light grade
oil supplied or a suitable alternative like sewing machine oil. Only this type of oil
is suitable due to the high oscillation speed of the blades on your Remington hair
clipper. Do not use hair oil, grease or any oil mixed with kerosene or any solvent as
the solvent will evaporate and leave the thick oil, slowing the blades.
If oil is not applied to the blades or only a small amount of oil is applied, this may
cause cutting problems. Blades will wear prematurely and not cut properly if they
are not sufficiently lubricated. There may also be a pulling sensation on the hair.
Instructions for Hair Cutting
NOTE: For even cutting, allow the trimmer comb/blade to cut its way through the
hair. Do not force it through quickly. If you are cutting for the first time, start with the
maximum length trimmer comb, until you know how short you would like your hair to be.
NOTE: The comb guide lengths described for use in the steps below are an
example only, if you want a longer or shorter hair cut you will need to adjust the
comb guide lengths to suit your requirements.
Comb Settings
MARK
LENGTH SETTING
Comb 1 - Short Comb 2 - Long
13mm 18mm
.4.5mm 19.5mm
36mm 21mm
.7.5mm 22.5mm
59mm 24mm
.10.5mm 25.5mm
712mm 27mm
.13.5mm 28.5mm
915mm 30mm

7
Step 1 - Nape of the Neck
1. Use 3mm or 6mm setting.
2. Hold the hair clipper with the blade teeth pointing upwards. Begin starting at
the centre of the head at the base of the neck.
3. Slowly lift the hair clipper, working upwards and outwards through the hair,
trimming just a little at a time.
Step 2 - Back and Side of the Head
With the 9mm or 12mm setting in place, cut the hair at the back of the head.
Step 3 - Side of the Head
With the 9mm or 12mm setting in place, trim sideburns.
Step 4 - Top of the Head
1. With the setting of your choice, cut the hair on top of the head against the
direction in which the hair normally grows.
2. For longer hair on top, use scissors. Lift the hair on top of the head with
styling comb. Cut over the styling comb with the hair lifted or hold the hair
between the fingers to lift it and cut it to the desired length.
3. Always work from the back of the head.
Step 5 - The Finishing Touches
1. Use the hair clipper without an attachment comb for close trimming around
the base and sides of the neck.
2. To produce a clean straight line at the sideburns, reverse the hair clipper.
Place the reversed hair clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
CLEANING & MAINTENANCE
To ensure long lasting performance of your hair clipper, clean the blades and unit regularly.
NOTE: Ensure that the hair clipper is turned off and unplugged when cleaning.
After Each Use
1. Ensure the hair clipper is switched off and disconnected from the mains
household power outlet.
2. Brush the accumulated hair from the blades. Do not submerge the hair clipper in water.
3. To clean the body of the unit, wipe with a damp cloth and dry immediately.
4. Gently brush the remaining hairs away from the hair clipper comb and hair
clipper blade. Do not rinse the cutter assembly under water.
Every Six Months
At regular intervals the blade set should be removed and cleaned.

8
1. Ensure that the hair clipper is empty of power, is switched off and
disconnected from the mains household power outlet.
2. Remove the comb attachment.
3. Hold the hair clipper in one hand so that the blades are at the top, and the
front of the hair clipper is facing you.
4. Place your thumb of the opposite hand underneath the blades at the front of
the unit, hold the back of the blade set with your fore finger and middle finger
and firmly press upwards with your thumb. The blade set will detach from the
hair clipper.
5. Brush the accumulated hair from the hair pocket and blades.
6. Replace the blade set by inserting the notch (on the inside at the bottom of
the blade set) into the groove of the hair pocket and firmly push down with the
palm of your hand until you hear an audible ‘click’ and the blade set is locked
into place.
Storage
When not in use, unplug the hair clipper and store it out of reach of children in a
safe dry place. Never wrap the cord around the hair clipper as this will cause the
cord to wear prematurely and break. Handle the cord carefully for long life and
avoid jerking, twisting or straining especially at the plug connections.
TROUBLESHOOTING
The hair clipper does not work when turned on:
Hair clipper must be charged for a full 16 hours, or use hair clipper while plugged
into wall.
Hair clipper cutters do not move:
The cutting unit may be dirty and clogged. Clean the unit as directed in Cleaning &
Maintenance section on page 7.
Hair clipper does not hold charge:
Fully discharge the battery by running hair clipper until it stops; then follow
recharging instructions in Charging Your Hair Clipper section on page 5.
THIS PRODUCT IS NOT SUITABLE TO USE IN THE BATH OR SHOWER.
This product conforms to radio frequency interference requirements
Any product purchased and used commercially carries a limited 90 Day Warranty.

9
IMPORTANT SAFETY INSTRUCTIONS FOR THE TRIMMERS
When using appliances, especially when children are present,
basic safety precautions should always be followed, including the
following:
• To prevent accidents keep the appliance away from your eyelashes
as well as clothes, brushes and wire.
• Always remember to turn on the trimmer before you insert it into
your nose or ear to avoid painfully snagging hairs.
• Never insert the trimmer more than 6mm (1/4”) into your nose or
ear. Foreign objects should not come into contact with your ear
drum.
• This appliance should not be used by children or other persons
with reduced physical, sensory or mental capabilities or lack
of experience and knowledge unless they have been given
supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
• This appliance is not a toy. Children shall be supervised to ensure
they do not play with the appliance. Cleaning and use maintenance
shall not be made by children without supervision.
• Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by Remington.
• Do not use on people who are asleep.
• Never drop or insert any object into any opening of this appliance.
• Do not use the trimmers with damaged or broken cutters, as injury
may occur.
• Always store the appliances in a moisture-free area. Do not store it
in temperatures exceeding 60°C (140°F).
• Do not disassemble the detail trimmer cutter assembly.
• Do not submerge the units in water as damage will occur.
• This appliance is for household use only.
SAVE THESE INSTRUCTIONS

HC9000AU REMINGTON POWER PRO TRIMMERS
Thank you for purchasing your new Remington®Power Pro Grooming Kit. Inside this
manual you will find tips on using and caring for your Detail Trimmer and Nose &
Ear Trimmer.
Detail Trimmer
1. Detail Trimmer Head Attachment
2. On/Off Switch
3. Battery Compartment
Nose & Ear Trimmer
1. Nose & Ear Trimmer Head
Attachment
2. On/Off Switch
3. Battery Compartment
Also Includes:
• 2 x AA batteries
KEY PARTS
10
1
2
3
1
2
3
Detail Trimmer
Nose & Ear Trimmer