FPEM-1210P-A0201L-V2:12 Bi-directional type inputs, 10
PNP type transistor outputs. 2 Analog inputs (16-bit
resolution) & 1 Analog output (12-bit resolution)
For more information, please refer user manual which
will be available in FlexiSoft software help and/or you
can download from REPL website.
Dimension Details:
24VDC (±15%), 12V from base
Input/channel: 24VDC, 5mA typical
Output/Channel: 250mA @ 24VDC
Optical Isolation for all I/O points. High
isolation voltage (BV= Greater than
1.5kV)
12 Inputs Bi-directional Type
10 PNP type transistor outputs
Analog Input Total Channels
2 Input channels (16 bit resolution)
0-20mA, 4-20mA & 0-10VDC, 0-5VDC
Analog Output Total Channels
1 Output channels (12 bit resolution)
0-20mA, 4-20mA and 0-10VDC, 0-5VDC
± 0.2% of full scale @ 25°C & ± 0.5% of
full scale over temperature range
Note:
In the Flexisoft select FPEM-1210P-A0201L or V2 for FPEM-1210P-
A0201L-V2 unit.
10 to 90% (Non-Condensing)
48mm x 108mm x 35.7mm (W x H x D)
**Operating temperature: For UL 0 to 50°C
Mounting with base models:
With the expansions, while unpacking the unit, user will
find two screws already attached with base bottom case.
Fix the expansion with the HMI as shown below with
these screws. Fix the Expansion connector with the
expansion female connector given on base HMI.
Apply torque 0.1Nm while fixing with base unit.
Mounting with 4.3” base model:
Mounting with 7” and 10.1” base model:
For 7” and 10.1” HMI models, the procedure of mounting
expansions is same. Only instead of horizontal mounting,
expansions will mount in vertical directions.
Hence, accordingly these bases are having facility to add
3 and 5 expansions at a time respectively.
Mounting with 7” base model:
Mounting with 10.1” base model:
[Note: All Pictures shown are for illustration purpose
only. Actual product size may vary.]
